Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Best on-line shop manual service
Replies: 1
by
hames57 »
Tue Jun 01, 2010 1:22 pm
Is there a really good on-line shop manual service for my '84 bronco II?? I've tried using one called Mitchells. Nothing there for the carb for...
1 Replies
1391 Views
Last post by onewontwo
Tue Jun 01, 2010 4:21 pm
Gearing
Replies: 2
by
jaydbaker »
Tue May 25, 2010 12:38 pm
1990 B2 differential gears wich are lower 5speed or auto and how can I determine what I have without dissasembly ?
2 Replies
1332 Views
Last post by jaydbaker
Tue Jun 01, 2010 2:01 pm
4 Replies
2482 Views
Last post by dixie281
Tue Jun 01, 2010 6:27 am
87 B 2 rear end nightmare
Replies: 5
by
zookeyknee »
Wed May 26, 2010 2:12 pm
I just replaced my CV drive shaft on 87 B 2 after much searching with a nice used double cardan one new yoke and oil seal also. The CV ran for a...
5 Replies
2226 Views
Last post by zookeyknee
Sat May 29, 2010 9:50 pm
2 Replies
1130 Views
Last post by drofman
Sat May 29, 2010 9:12 am
need help clutch
Replies: 4
by
bkimbrel »
Thu May 06, 2010 1:07 pm
i have a 1984 bronco 2 everytime i push the clutch in the hydraulic clutch line is sucking in air,does anyone know where i can get a new clutch line...
4 Replies
2961 Views
Last post by Skywagon Jim
Fri May 28, 2010 11:53 am
body lift question
Replies: 5
by
90redb2 »
Mon May 24, 2010 5:38 pm
i am looking at ordering a 3" body lift for my 1990 bronco 2 so that i can clear some 31x10.5 r15s and i am just wondering if i will need to order...
5 Replies
1975 Views
Last post by 90redb2
Tue May 25, 2010 4:31 pm
b2 dies over bumps
Replies: 4
by
b2 bomber »
Thu May 20, 2010 2:04 pm
New here...Has anyone had the problem of dying over tracks or rough road?? A little history, I've owned this b2 for 2 months and have done the...
4 Replies
2251 Views
Last post by drofman
Mon May 24, 2010 10:40 am
1 Replies
1497 Views
Last post by Phillippi
Sun May 23, 2010 12:58 pm
tire size
Replies: 1
by
90redb2 »
Mon May 17, 2010 7:52 pm
hey i am lifting my 1990 bronco 2 with some explorer suspension so i should be getting about 2-2.5 inches of lift. i was woundering if i would be...
1 Replies
1012 Views
Last post by Phillippi
Sun May 23, 2010 12:57 pm
NEED HELP WITH 88 BRONCO II, PLEASE HELP!!
Replies: 16
by
damon »
Thu Apr 22, 2010 8:36 am
I GIT AN 88 BRONCO 4 FREE, BECAUSE MY CAR BROKE DOWN 2 YEARS AGO, RIGHT AFTER MY DAD DIED. I HAVE HAD ENOUGH PROBLEMS TO WRITE A COUNTRY SONG. MAJOR...
16 Replies
10604 Views
Last post by bronco_lou
Fri May 21, 2010 5:58 pm
86 b2 zero fuel pressure?
Replies: 1
by
Daehtop »
Wed May 19, 2010 8:39 pm
so about a week ago i was finally able to drive my b2 home from a friends, where i had been working on it finishing my 4-link in the front. it had...
1 Replies
1474 Views
Last post by KRE
Thu May 20, 2010 2:59 pm
Service Manuals GALORE
Replies: 2
by
oneway »
Sat May 15, 2010 5:54 pm
Go to this website:
2 Replies
1455 Views
Last post by tekatlarge
Wed May 19, 2010 8:22 pm
1989 bronco ii using water
Replies: 7
by
dragster557 »
Sun May 16, 2010 7:29 pm
It pulls water from recovery tank overnight like it should.But it never pushes water in it when hot so i have to add water.Have pressure checked cap...
7 Replies
3807 Views
Last post by KRE
Wed May 19, 2010 5:35 am
'85 hatch fit an '87
Replies: 3
by
joeyy »
Sun May 16, 2010 9:52 pm
I got an '87 Bii eddie bauer, I was wondering if the hatch off a '85 would fit my truck. i dont really know anything about the '85 i saw it in the...
3 Replies
2712 Views
Last post by XR75ER
Tue May 18, 2010 7:51 pm
b2 ranger tail gate conversion
Replies: 6
by
XR75ER »
Sat May 01, 2010 6:27 pm
eek:started the tailgate conversion today.
6 Replies
4164 Views
Last post by 303lithgow
Tue May 18, 2010 11:07 am
84 2.8L overheating badly
Replies: 3
by
Colin »
Thu May 06, 2010 2:36 pm
I bought this vehicle a few months back and had an awful job getting it smogged. My smog tech told me he had fitted a new thermostat because it was...
3 Replies
3028 Views
Last post by drofman
Sat May 15, 2010 5:42 pm
Front Axels Swap.
Replies: 1
by
Dave »
Sat May 15, 2010 2:21 pm
I recently broke one of my front passenger side axels on my 88 Bronco II. Im trying to find out what other axles will work. I've decided to go with...
1 Replies
824 Views
Last post by Ranger Dave
Sat May 15, 2010 3:28 pm
6 Replies
4036 Views
Last post by Falec70
Fri May 14, 2010 5:45 pm
84 Bronco not getting gas???
Replies: 3
by
chilnboc »
Sun May 09, 2010 11:51 pm
Was running fine until it ran out of gas... Then it started acting up like it wasn't getting gas. replaced the fuel filter and fuel pump still did...
3 Replies
1515 Views
Last post by chilnboc
Thu May 13, 2010 9:03 pm
Problem with Body Lift
Replies: 3
by
Dieselmech52 »
Thu Apr 15, 2010 5:33 pm
Well, here's the story. I am in the middle of a 2" body lift on my 85 B2 so I can clear my new 31x10.50 treadwrights and ran into a little problem. I...
3 Replies
2618 Views
Last post by tickturd
Thu May 13, 2010 6:31 pm
American outlaw 2 series....
Replies: 1
by
FilthyBronco »
Tue May 04, 2010 11:14 am
What the biggest i can go in this particular rim on a 1989 ford bronco II EB edition? I like this rims but i would like to c them in 18" for my...
1 Replies
1333 Views
Last post by 303lithgow
Thu May 13, 2010 7:55 am
Axle question? Rear dana 35
by
aarnwts »
Wed May 12, 2010 7:09 am
will an axle from a jeep (dana 35) bolt in on my 1990 bronco II I currently have a 35 on it. Just wondering if it will bolt on rear ends are hard to...
0 Replies
1529 Views
Last post by aarnwts
Wed May 12, 2010 7:09 am
Manual Trans V.S. Auto Trans
Replies: 2
by
Bronc 2 84 »
Sun May 09, 2010 6:36 pm
I'm gonna be doing an engine swap to my 84 BII.I'm putting in a 302.My question is should I put in an Auto or Manual tranny for 4 wheelin and being a...
2 Replies
1830 Views
Last post by tekatlarge
Tue May 11, 2010 7:54 pm
1986 Bronco II, low oil pressure
Replies: 6
by
303lithgow »
Wed Apr 28, 2010 10:39 am
I bought an 86 Bronco II last week with the 2.8 engine and the oil pressure always seems low, even when cold. Is this common?
6 Replies
3442 Views
Last post by 303lithgow
Tue May 11, 2010 6:59 pm
cut and turn ttb axles
by
tickturd »
Tue May 11, 2010 6:19 pm
how is this done, i have a pretty good idea, but i was wondering is, how do you figure how far to bend the cut. i was wondering also if it could be...
0 Replies
2048 Views
Last post by tickturd
Tue May 11, 2010 6:19 pm
2 Replies
1632 Views
Last post by 303lithgow
Tue May 11, 2010 5:28 pm
1986 Bronco II, speed control
Replies: 8
by
303lithgow »
Wed Apr 28, 2010 11:47 am
Anyone know about speed controls? Mine doesn't work. When I bought the Bronco last Friday it didn't work, or the emergency flashers or the brake...
8 Replies
4143 Views
Last post by 303lithgow
Sun May 09, 2010 8:40 pm
2 Replies
1735 Views
Last post by aarnwts
Sun May 09, 2010 10:04 am
Voltage to Ignition Coil-No spark-Help
Replies: 3
by
bronco2MGM »
Wed Mar 24, 2010 9:57 pm
Okay, here goes. I have no spark, I got spark once but not again. I have replaced the ignition coil, relay checked ground connections, connections...
3 Replies
1680 Views
Last post by KRE
Sun May 09, 2010 6:07 am
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum