Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Transmission question
Replies: 6
by
robwide »
Sat Jan 30, 2010 1:39 pm
Will a 91-93 Ford Mustang A4LD 2.3L Automatic O/D Transmission work in an 88 Bronco II 4x4 2.9L XLT?
6 Replies
2358 Views
Last post by robwide
Sat Feb 13, 2010 9:53 am
axles replace
Replies: 5
by
rockhound »
Mon Feb 08, 2010 5:36 pm
i have a 88 b2 4wd 2.9 my front axle is dana28 i want to replace axle with something i can install limited slip in (front)
5 Replies
2053 Views
Last post by joeyy
Fri Feb 12, 2010 2:27 pm
A4LD swap question
by
forman621 »
Fri Feb 12, 2010 11:24 am
hey i got a automatic tranny from a 93 ranger. and i put it in my 86 bronco II. the overdrive wire doesnt hook up because one is a three wire...
0 Replies
1265 Views
Last post by forman621
Fri Feb 12, 2010 11:24 am
wiper linkage problems
Replies: 4
by
skag101 »
Tue Feb 09, 2010 1:21 pm
Hey. I am looking for wiper linkage for my 1988 Bronco II. The metal clip on the end has rusted and broken off and the linkage will not stay on. Does...
4 Replies
1805 Views
Last post by Ranger Dave
Fri Feb 12, 2010 1:01 am
front dana 35 info
Replies: 1
by
rockhound »
Thu Feb 11, 2010 5:46 pm
hi have 88 b2 and im going to replace the dana 28 with explorer 1993 front suspension d35 is there a limited slip,or trac lock available i dont want...
1 Replies
738 Views
Last post by Ranger Dave
Fri Feb 12, 2010 1:01 am
Front Driveshaft Dilemma...
Replies: 16
by
Bronkitis »
Wed Feb 10, 2010 2:59 pm
1988 BII. Previous owner converted from auto to a stick which I believe is the mitsubishi out of another BII. The front shaft that came with it does...
16 Replies
5365 Views
Last post by Ranger Dave
Fri Feb 12, 2010 12:59 am
86 Bronco II still running rough
Replies: 12
by
forman621 »
Fri Jan 22, 2010 6:37 pm
A couple days ago i thought i fixed my hesitation problem by putting the oxygen sensor in. it ran better for a while. within two days it started this...
12 Replies
6307 Views
Last post by dub2bronco2
Wed Feb 10, 2010 6:39 pm
Spare tire bushing
Replies: 5
by
drofman »
Sat Feb 06, 2010 6:33 pm
Does anyone know were I can get that hard plastic bushing that goes from the spare tire carrier pipe to the hatch mount? I've cut a Rad hose and...
5 Replies
2828 Views
Last post by clem
Tue Feb 09, 2010 2:20 am
What is this clunking sound??
Replies: 2
by
tonymasone »
Sun Feb 07, 2010 9:00 pm
When driving my 89 b2, I've noticed the steering feels out of wack (pulling to the right) and when I hit pot holes or decent sized bumps I can feel...
2 Replies
958 Views
Last post by Phillippi
Mon Feb 08, 2010 9:56 pm
got me a factory lift
Replies: 2
by
Ranger Dave »
Mon Feb 08, 2010 4:34 pm
never installed
2 Replies
1335 Views
Last post by drofman
Mon Feb 08, 2010 6:58 pm
noob need some help please
Replies: 3
by
BIGorange2 »
Mon Feb 08, 2010 11:16 am
OK so i just got a beautiful 1984 orange B2 and i was looking under the hood to see why it will not start and i noticed that at the starter sellunoid...
3 Replies
1524 Views
Last post by drofman
Mon Feb 08, 2010 6:21 pm
84 bronco 2 top speed 40-45mph????
Replies: 4
by
Bronc 2 84 »
Sat Feb 06, 2010 10:04 am
For some reason my truck won't go faster than 40-45mph.I can't figure it out.The info on the truck is
4 Replies
2188 Views
Last post by 1highlander
Mon Feb 08, 2010 3:22 pm
0 Replies
893 Views
Last post by sdhawks
Sun Feb 07, 2010 10:10 am
BW1350 conversion
Replies: 2
by
Bronkitis »
Sat Feb 06, 2010 9:29 am
New to forum and BII's so please bear with me! :laugh: Bought an 88' last night with 2.9 and the touch drive system. Guy I got it from converted from...
2 Replies
1024 Views
Last post by Ranger Dave
Sat Feb 06, 2010 1:17 pm
Engine additives
Replies: 6
by
justinaron »
Sat Jan 30, 2010 6:21 pm
Has anyone tried any additives that fix blown head gaskets/ cracked heads... do any of them work? Which one is the best for the money :eek:
6 Replies
2265 Views
Last post by tekatlarge
Fri Feb 05, 2010 5:45 pm
Tires.
Replies: 2
by
tasteofkaos »
Thu Feb 04, 2010 6:20 pm
What size and type would be good for my 90 ford bronco 2. I drive mostly on the road but want bigger tires. I also wanna start going mudding! (15...
2 Replies
978 Views
Last post by tasteofkaos
Fri Feb 05, 2010 4:39 pm
bogging
by
dub2bronco2 »
Fri Feb 05, 2010 2:52 pm
finally got the bronco running decent. found a kinked fuel line, replaced and the motor finally ran smooth. Now have a new problem which seems the...
0 Replies
922 Views
Last post by dub2bronco2
Fri Feb 05, 2010 2:52 pm
My 2.9 Problem starting
Replies: 17
by
justinaron »
Mon Jan 18, 2010 7:33 pm
I have a 87 2.9. Its not the best looking motor but she ran. I took off from a red light and it didn't have alot of power like i only could go 5...
17 Replies
6242 Views
Last post by drofman
Thu Feb 04, 2010 7:52 pm
loud clank sound
Replies: 3
by
yoshie1976 »
Tue Feb 02, 2010 6:23 am
I replaced my rear driveshaft last week. It drove fine for 4 or five days, and today as I was pulling away from a stop light there was a loud clank....
3 Replies
1617 Views
Last post by kolton
Wed Feb 03, 2010 7:03 pm
Worth the trouble?
Replies: 3
by
yardboss »
Sat Jan 30, 2010 12:23 pm
Found a 1984 bronco 2 with a drivers side busted knuckel for 400. I havent seen it in person but everything works ok from what he says. Is it worth...
3 Replies
1182 Views
Last post by drofman
Wed Feb 03, 2010 6:55 pm
89 2.9L idle loping
Replies: 1
by
dragster557 »
Sun Jan 31, 2010 5:57 pm
For about 2 mins. after i crank it,the idle lopes like a super charger and the smooths out.What could this be.New to board.Thanks for any help.
1 Replies
783 Views
Last post by drofman
Sun Jan 31, 2010 7:59 pm
2.8 - 2.9 swap
Replies: 5
by
broncojeremy »
Wed Jan 20, 2010 5:49 pm
how hard is it to swap from a 2.8 to a 2.9 as far as the wiring and stuff goes?
5 Replies
2226 Views
Last post by Colin
Sun Jan 31, 2010 5:46 pm
84 4.0 upgrade
Replies: 3
by
bronco2newbie »
Mon Jan 25, 2010 11:30 am
I see alot of tech knowlage on these forums. I was wondering if there is a site or discussion about putting a 4.0 where a 2.8 used to be. I have the...
3 Replies
1244 Views
Last post by bronco2newbie
Sun Jan 31, 2010 3:12 am
Bronco II 2.9L Heads Need Fixin'
Replies: 20
by
BroncoNoob »
Sun Oct 11, 2009 11:34 pm
So I am working on fixing up a the Bronco that my sister abandoned at my house. It is a 1987 with the 2.9L V6 Engine. She overheated the engine...
20 Replies
10878 Views
Last post by drofman
Sat Jan 30, 2010 8:39 pm
4.0 falling on its face
Replies: 3
by
sdhawks »
Fri Jan 29, 2010 6:30 pm
ite iv got a 89 bronco 2 with 4.0 swap and it ran fine for a bit i just bought it, all the work was done but it ran ruff, i changed the tps...
3 Replies
1263 Views
Last post by Colin
Sat Jan 30, 2010 6:24 pm
sad day today... will this work as a fix?
Replies: 2
by
kolton »
Fri Jan 29, 2010 11:23 am
driving home from work today, the car in front of me on the highway lost controll and spun round towards me. i went into the barditch to find out...
2 Replies
1146 Views
Last post by kolton
Sat Jan 30, 2010 9:50 am
Door Handle Fix
by
Blue8844 »
Fri Jan 29, 2010 2:06 pm
Hey everyone,
0 Replies
1082 Views
Last post by Blue8844
Fri Jan 29, 2010 2:06 pm
Fuel guage reads full always
Replies: 6
by
Bones »
Tue May 13, 2008 10:51 am
OK so I have had this problem since I did the Xploder swap in my 86 BII 2 years ago, lol. I figured out mileage and always error on the put more fuel...
6 Replies
3106 Views
Last post by drofman
Thu Jan 28, 2010 6:49 pm
0 Replies
846 Views
Last post by flyrickd3
Thu Jan 28, 2010 6:24 pm
4x4 Issue?
Replies: 9
by
CVCS »
Mon Jan 11, 2010 10:31 pm
Alright, When I Put My Bronco Into 4x4, The Front Wheels Start Feeling Weird. Every Time I Give It Gas, It Feels Like It Slips, Than Grabs And Drives...
9 Replies
3451 Views
Last post by CVCS
Tue Jan 26, 2010 3:51 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum