Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
A4LD Transmission high rpm's before shifting
Replies: 9
by
jefe »
Wed Jul 18, 2012 9:15 am
Hey guys...got an 87 BII 2.9L 4WD with the A4LD transmission.....past couple weeks or so, it's been slow to shift gears, rpm's going up to about 4000...
9 Replies
5998 Views
Last post by kirkland2887
Wed Aug 01, 2012 8:18 pm
2.9 to 5.0
Replies: 4
by
Jbots »
Wed Jul 25, 2012 1:23 pm
Hey guys had a few questions on this swap i wanna do, will the 2.9 tranny bolt up to the 5.0? Any other input would be appreciated thanks
4 Replies
2883 Views
Last post by tekatlarge
Mon Jul 30, 2012 2:57 pm
Value of Eddie Bauer Bronco II
Replies: 2
by
BroncoNick »
Sun Jul 15, 2012 9:01 am
Hello,
2 Replies
1602 Views
Last post by RAZOR
Fri Jul 27, 2012 4:21 pm
302 or 351m?
Replies: 9
by
shazbot »
Fri Jul 13, 2012 11:56 am
I got a 351w that my father and grandpa modified, it has the same bell housing as the 302. should i pull the 351 out of the truck I do not drive...
9 Replies
5450 Views
Last post by shazbot
Wed Jul 25, 2012 11:42 pm
Help, oil pump
Replies: 6
by
purgatorywalker »
Thu Jul 19, 2012 7:17 pm
Where is located the oil pump (B2 84 2.8L)? Some oil is spilling and can't figure out where it comes from, the area is hard to see and reach. I...
6 Replies
2910 Views
Last post by drofman
Tue Jul 24, 2012 8:31 pm
2 Replies
1272 Views
Last post by purgatorywalker
Thu Jul 19, 2012 7:04 pm
trouble shooting
Replies: 18
by
Jbots »
Sat Jun 23, 2012 8:51 pm
hey guys just picked up my bronco 2 from packwood really excited to buy it being that it was my grandparents and i found the people that owned it and...
18 Replies
8009 Views
Last post by drofman
Tue Jul 10, 2012 4:52 pm
Bronco II Body mount
Replies: 18
by
LarryA »
Fri Apr 28, 2006 4:04 pm
Looking for a place to purchase a new, used, or fabricated left center body mount bracket (current is riveted to frame). I have this a 1990 Bronco II...
18 Replies
10153 Views
Last post by dgl6y6
Sat Jul 07, 2012 8:59 am
distibutor cap
Replies: 2
by
kirkland2887 »
Thu Jul 05, 2012 5:22 pm
So i have been playing in the mud a lot and can't seem to keep water and mud out of my distibutor cap. does anybody have any ideas on how i can keep...
2 Replies
2236 Views
Last post by Ranger Dave
Fri Jul 06, 2012 2:42 am
Roof insulation material...
Replies: 11
by
jefe »
Tue May 01, 2012 11:11 am
Hey guys.
11 Replies
5146 Views
Last post by jefe
Tue Jun 26, 2012 9:14 pm
loud rearend noise
Replies: 18
by
4d4life »
Thu Jan 26, 2012 9:32 am
have a 88 brono ii everytime turn right, a hard right, at about 20mph theres a pop in the rear end. it usually pops about 3 times. any ideas?
18 Replies
8345 Views
Last post by jefe
Mon Jun 25, 2012 10:13 pm
9" Axle Bearing Question
Replies: 1
by
orcus420 »
Fri Jun 22, 2012 6:04 pm
I have a 9 (big bearing ends) from a 74EB under my BII and swapped in a Detroit with 31-spline Yukons a few years ago. One side started leaking a bit...
1 Replies
1663 Views
Last post by drofman
Fri Jun 22, 2012 7:58 pm
auto tranny help?!?!
Replies: 1
by
88_bug_out »
Thu Jun 14, 2012 7:30 pm
Ok heres the tale of the take i have an 88 b2 4x4, 2.9, auto trans, manual shift t-case, and manual lock out hubs.(all stock and hasnt been moved...
1 Replies
1324 Views
Last post by Mudhog1977
Sun Jun 17, 2012 5:59 am
Somebody Help With This Please
Replies: 9
by
EFSleeper »
Thu May 10, 2012 1:29 am
Ok so I have been scratching my head on this for a while. I have replaced every fuel line from the tank to under hood, also have replace o rings on...
9 Replies
4637 Views
Last post by Mudhog1977
Sun Jun 10, 2012 1:53 pm
b2 dash
Replies: 2
by
john_adam_turbo »
Mon Jun 04, 2012 9:31 am
I got an 85 b2 and was wondering if a 90 dash would fit. Im guessing i would have to get ducting for the a/c but i dont know how much work it would be
2 Replies
1142 Views
Last post by john_adam_turbo
Thu Jun 07, 2012 6:34 am
A4LD Casting Numbers.
by
tekatlarge »
Tue Jun 05, 2012 10:20 am
I am trying to locate casting numbers for the Infamous A4LD. I think I remember a discussion about which A4LD case was a better candidate for...
0 Replies
2307 Views
Last post by tekatlarge
Tue Jun 05, 2012 10:20 am
2.3 turbo swap in broncoll
Replies: 3
by
barrylee66 »
Sat May 19, 2012 6:45 pm
2.3 turbo blow thru in 87bronco2. it has an automatic trans and a 2.9 will this trans work with a 2.3 will the bell housing come off the trans. or do...
3 Replies
2184 Views
Last post by drofman
Mon May 28, 2012 8:23 pm
runs untill its warm (video)
Replies: 32
by
UndeadBronco »
Wed Jun 09, 2010 8:06 am
87 Bronco II I got working finally by replacing the TFI and it worked for about a week with no porblems. Now the weather has gotten a bit hotter and...
32 Replies
13631 Views
Last post by tekatlarge
Mon May 28, 2012 2:51 pm
2 Replies
1351 Views
Last post by bronco4x4
Fri May 25, 2012 7:55 am
Really? Still with the brakes.
Replies: 1
by
danboy282 »
Fri May 18, 2012 9:34 am
Well, i have changed everything but the booster, rear hose, and metal lines. Front brakes were still building too much pressure. When checking and...
1 Replies
1171 Views
Last post by kirkland2887
Tue May 22, 2012 8:54 pm
Fuel problems
Replies: 8
by
Zackman6 »
Sat May 05, 2012 8:04 pm
So my 86 was runnin like a champ then one day it wouldn't start when I was going to work. I noticed the fuel pumps weren't kicking on when I turned...
8 Replies
3425 Views
Last post by Zackman6
Fri May 18, 2012 8:43 am
Suspension question
by
B2crawler »
Tue May 15, 2012 10:40 am
I'm new to the forum and I'm thinkin about building an 88 bronco 2 for a rock crawler and have a question on suspension. How much lift can I get out...
0 Replies
2840 Views
Last post by B2crawler
Tue May 15, 2012 10:40 am
slave cylinder?
Replies: 1
by
kirkland2887 »
Sat May 05, 2012 2:49 pm
I need to put a new slave cylinder in my 89 but I can't get the hydraulic line to disconnect. the new slave came with a little plastic tool and the...
1 Replies
1162 Views
Last post by kirkland2887
Sun May 13, 2012 3:49 pm
Bronco ii '88 runs poorly no speed
Replies: 9
by
jgarza »
Sun May 06, 2012 8:33 am
Hi so I have my 88 bronco and we just replace the transmission and it's been running poorly. I press the gas and it seems like no gas is reaching the...
9 Replies
3424 Views
Last post by tekatlarge
Wed May 09, 2012 9:52 pm
Pressure differential valve?
by
danboy282 »
Tue May 08, 2012 7:40 am
I can't seem to locate a proportioning valve or a pressure differential valve.
0 Replies
2496 Views
Last post by danboy282
Tue May 08, 2012 7:40 am
0 Replies
2741 Views
Last post by jgarza
Sun May 06, 2012 9:48 pm
Need advice on installing a/c
Replies: 5
by
wyobuck »
Mon Apr 30, 2012 1:35 pm
Bought a like new 1989 BII XL with 43,000. Super condition. I am in FL so I really need A/C and this XL did not come with it, it was a OR car. So how...
5 Replies
2926 Views
Last post by wyobuck
Sat May 05, 2012 12:33 am
Fuel problem
Replies: 2
by
Zackman6 »
Mon Apr 30, 2012 6:47 am
Ok so yesterday out of nowhere my '86 bii didn't want to start, I traced the problem to the fuel system, I didn't hear the fuel pump kick on when I...
2 Replies
1191 Views
Last post by Zackman6
Mon Apr 30, 2012 9:33 pm
Noise in transmission
Replies: 2
by
Bronco11Guy1211 »
Fri Apr 27, 2012 10:57 am
1985 B2 2.8l V6, fm145 mitsubishi manual transmission
2 Replies
1706 Views
Last post by Bronco11Guy1211
Sat Apr 28, 2012 10:42 am
1 Replies
1041 Views
Last post by drofman
Fri Apr 27, 2012 4:36 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum