Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
1990 Bronco ii wont start
Replies: 1
by
Garcia831 »
Thu Mar 04, 2010 5:34 pm
ok were to start
on our last trip to the hills we took my bronco it was running pretty good at first, we drove for about an hour maybe and then we...
1 Replies
780 Views
Last post by clem
Thu Mar 04, 2010 5:47 pm
A4LD reverse and overdrive not working
Replies: 11
by
robwide »
Sun Feb 28, 2010 8:20 pm
ok another tranny question.
When I bought the 88 BR2 with an A4LD in it I was told that reverse had gone out of it.
He took it in to have the tranny...
11 Replies
2650 Views
Last post by robwide
Thu Mar 04, 2010 9:25 am
fuel pump not primeing
Replies: 1
by
86b2 »
Wed Mar 03, 2010 5:03 pm
i just replaced my fuel pump on a 86 and thers no fuel pressure it dosent prime or anything so does anyne know were the fuel pump fuses are or have...
1 Replies
462 Views
Last post by Ranger Dave
Thu Mar 04, 2010 1:07 am
dana 35 trac lock and differential?
Replies: 1
by
rockhound »
Tue Mar 02, 2010 7:12 pm
ive purchased a dana 35 axle complete out of a 1990 explorer for 88 b2, made sure it wasnt a dana 28 inerds thanks site for all the great dana 35...
1 Replies
680 Views
Last post by Ranger Dave
Wed Mar 03, 2010 1:05 am
2 Replies
1159 Views
Last post by mattstover52
Tue Mar 02, 2010 2:56 pm
removing cruise controll stuff
by
brother-moe »
Tue Mar 02, 2010 9:49 am
so, i have come to a conclusion that since my cruise controll dosnt work and i dont really care for it anyway, i want to remove all the vacuume lines...
0 Replies
879 Views
Last post by brother-moe
Tue Mar 02, 2010 9:49 am
9 Replies
6255 Views
Last post by redemption
Mon Mar 01, 2010 6:42 pm
my fuel guage quirk
Replies: 5
by
zookeyknee »
Thu Feb 25, 2010 10:58 pm
My 87 B 11 The guage works ie it goes from full to empty after filling up at a normal rate. Trouble is when it hits E or I let it get below E,the...
5 Replies
1961 Views
Last post by drofman
Mon Mar 01, 2010 4:55 pm
Valve cover seals?
Replies: 3
by
joeyy »
Sun Feb 28, 2010 12:58 am
Im loosing oil pretty bad, im pretty sur eits the valve cover seals to blame. Its a 87 BII 2.9L. My question is how hard is it to actually change out...
3 Replies
1505 Views
Last post by joeyy
Mon Mar 01, 2010 12:56 pm
1 Replies
544 Views
Last post by Ranger Dave
Sun Feb 28, 2010 11:00 am
86 bronco needs help
Replies: 3
by
gmpsr »
Sat Feb 27, 2010 10:20 am
86 bronco after driving awhile it seem to ack like its running out of gass and then it will cut out,start back up find but when i try to drive it...
3 Replies
1154 Views
Last post by drofman
Sun Feb 28, 2010 8:53 am
help please
Replies: 12
by
BIGorange2 »
Fri Feb 12, 2010 2:25 pm
I need help with my starter selnoid Im missing a wire and i dont know where it goes to i know its suppose to go to the igniton but i dont know how so...
12 Replies
5521 Views
Last post by broncofan
Sun Feb 28, 2010 5:57 am
Rocker arm noise.
Replies: 4
by
cajun66 »
Sat Feb 27, 2010 6:29 am
I have a light tapping noise coming from the rear of my driver side valve cover. I was told that my 2.8 is a solid lifter motor. So are the rocker...
4 Replies
1959 Views
Last post by cajun66
Sat Feb 27, 2010 7:01 pm
tail light wiring
Replies: 6
by
tickturd »
Tue Feb 16, 2010 12:22 pm
the only lights that work is the back up lights . and the only time they come on is when the turn signals or step on the brake. also there is a...
6 Replies
2824 Views
Last post by drofman
Sat Feb 27, 2010 8:23 am
3 Replies
1188 Views
Last post by zookeyknee
Thu Feb 25, 2010 8:31 pm
84 Bronco Ignition problem
Replies: 4
by
broncoman05 »
Sun Jan 31, 2010 6:21 pm
Hey guys, I am new to the Bronco world, just got one Friday. I got it running but we cannot get it to crank with the key, we have to cross the...
4 Replies
2100 Views
Last post by smcpeake
Wed Feb 24, 2010 8:41 pm
Turn Signal
Replies: 4
by
slnetx »
Mon Feb 22, 2010 11:06 am
When I use my right turn signal the Green arrow doesn't light up or blink and neither do the exterior front right turn signal or right rear tail...
4 Replies
1317 Views
Last post by drofman
Wed Feb 24, 2010 7:29 pm
Went through water stalled out help!!
Replies: 14
by
aarnwts »
Tue Feb 16, 2010 7:24 am
86 Ford Bronco II 2.9L EFI
the water wasnt too deep up to the bottom of my door. I went through the large puddle twice with no problems. My gas is...
14 Replies
3448 Views
Last post by tekatlarge
Tue Feb 23, 2010 8:10 pm
blew a fuse somewhere
Replies: 1
by
The B-Wagon »
Fri Feb 19, 2010 11:31 pm
so this is basic automotive common sense i know. anyways i turned the key the other morning when the lights came on there was a loud pop ( like a...
1 Replies
621 Views
Last post by drofman
Tue Feb 23, 2010 5:50 pm
AXLES????
Replies: 1
by
hblydlx »
Mon Feb 22, 2010 8:09 pm
i got an 88 with stock running gear other than 4spd standard swap from 83 ranger i plan on replacing 2.9 with a 4.0L
and running 33 tire my question...
1 Replies
774 Views
Last post by Ranger Dave
Tue Feb 23, 2010 1:00 am
Dana 28 drop brackets?
by
wcampbell4 »
Sun Feb 21, 2010 10:46 pm
I am new to all this yet and like everyone else one upgrade has led to another...haha
I started off wanting just a small lift but now I'm at 4+ and...
0 Replies
923 Views
Last post by wcampbell4
Sun Feb 21, 2010 10:46 pm
Rear seal on FM145
Replies: 4
by
cajun66 »
Thu Feb 18, 2010 7:13 pm
Looks like I need a new rear seal on my 5 speed (FM145). I noticed a fresh spot of gear oil coming from between the transfer case and the...
4 Replies
1108 Views
Last post by cajun66
Sat Feb 20, 2010 4:22 pm
I want a strieght Axle
Replies: 3
by
aarnwts »
Fri Feb 19, 2010 5:26 pm
86 ford bronco II 2.9 l
what axle should I use for my front.
After my new motor thats whats next.
3 Replies
856 Views
Last post by Ranger Dave
Sat Feb 20, 2010 12:58 am
2 Replies
818 Views
Last post by cajun66
Tue Feb 16, 2010 5:21 pm
Threw a bearing
by
joeyy »
Tue Feb 16, 2010 1:19 pm
So i was driving down the road and I must have thrown a bearing or something on my driver side front wheel and it destroyed all the other bearings,...
0 Replies
934 Views
Last post by joeyy
Tue Feb 16, 2010 1:19 pm
4.0L swap
Replies: 2
by
The B-Wagon »
Sun Feb 14, 2010 10:45 pm
so heres the run down, this is going to be my first engine swap. the recieving vehicle is my 1990 bronco II, the donor vehicle is a 2001 ford...
2 Replies
789 Views
Last post by The B-Wagon
Mon Feb 15, 2010 4:25 pm
Explorer springs vs. XJ springs
by
Bronkitis »
Mon Feb 15, 2010 11:03 am
I have read that putting explorer front springs will give you a little lift as well as Cherokee springs. Question is which would be best? I have a...
0 Replies
1220 Views
Last post by Bronkitis
Mon Feb 15, 2010 11:03 am
Trans fluid in trans and transfer case.
Replies: 3
by
cajun66 »
Sat Feb 13, 2010 9:08 pm
I'm just about through with my automatic to manual swap and I need to fill the transmission and transfer case with fluid. What grade ATF do I need?
3 Replies
1438 Views
Last post by cajun66
Sun Feb 14, 2010 6:17 am
Transmission question
Replies: 6
by
robwide »
Sat Jan 30, 2010 1:39 pm
Will a 91-93 Ford Mustang A4LD 2.3L Automatic O/D Transmission work in an 88 Bronco II 4x4 2.9L XLT?
It has the A4LD OD floor shift.
Thanks
Robert
6 Replies
2233 Views
Last post by robwide
Sat Feb 13, 2010 9:53 am
axles replace
Replies: 5
by
rockhound »
Mon Feb 08, 2010 5:36 pm
i have a 88 b2 4wd 2.9 my front axle is dana28 i want to replace axle with something i can install limited slip in (front)
ive been told an explorer...
5 Replies
1916 Views
Last post by joeyy
Fri Feb 12, 2010 2:27 pm
Forum permissions
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum