BroncoII4x4.com

hi im new here and i recently bought a b2 and i live in ut a couple of hrs from moab i was in the junkyard last week and i spoted a b2 and the rear tag read 4ls10 or 4sl10 not 4l10 my b2 has an open 345 i read somewhere that the 4ls10 is limited slip but some sort of spring clutch or something would that b a good swap for my b2 and if so how difficult is that to do

If you are looking to swap out the entire axle, its not hard at all. Just replace. If you are looking to setup a LS carrier in our current axle, then you have to set up it correctly which is more of a specialty.

Where in UT are you? I am in Utah County.