BroncoII4x4.com

Ok started my bronco ll switch not what I really wanted but it will work change over from auto to manual .
I know it is not very exciting but its what I have right now.

Pictures, pictures, pictures, pictures

Well that did not work out blasted comp. OK the blue one is the 89 it had the a4ld the brown one has 89 motor and fm146 tranny witch I put in now I am taking them out as one so I do not have to go buy another slave cyclinder.
so the motor and tran. is out of brown one and starting to remove out of blue one.

It is out now to clean add parts that will be needed and if I could figure out this pic thing I will post.

ok now I figure it out blast

this is going in

Ya got half the battle done. What are you going to have to do about power brakes and room for the clutch master Cylinder? I didn't see how the brown one was setup?

Ok i hope it fits just like this right behind the power brake I just got the blue one cleaned so I can check it out if I have to I will used the one out of the brown one.

Hey I think I have this pic thing figure out now they wont take up the hole page

ok clutch master cylinder,Brake and clutch pedals in and power brakes back in.

OK I am back ok A little paint and some sand blasting to clean the air intake up and then put the exhaust back and the motor

OK it is in now all I have to do is remember where everything goes???