BroncoII4x4.com

had to replace my headgaskets after a burst rad hose caused my v6 to cook and burnt the gaskets in between the middle and out pistons.. so now replacing them but i am unsure if i put em on right last time as i have heard they go on a certain way but theres no markings on the gaskets themselves

is there a right and wrong way to fit them?
if so which way round do they go..?

pic below for reference



need to know cos we are motor less since wife blew turbo on her daily driver

look again, says "front/up"

nothing on my gaskets just couple of part numbers....? hence why i asked on here just to be sure i do it right

every set of gaskets i have bought have " front of up" on them

must be the unlucky one who has found ones that dont say then.. all i need is a decent pic of one showing which way it goes or the markings on them and i will be sorted

hang on

this is a 3.0 but there all marked