Page 1 of 1
prolly a stupid ??? but
Posted: Sun Oct 17, 2004 7:14 am
by Ranger Dave
here goes
can you thak the axel tubes off a low pinion D44 and turn the center section around to make a high pinion.Just tring to think of a way to get less of a driveshaft angle
Posted: Sun Oct 17, 2004 7:47 am
by Nobody
No, the axle would turn backward.
Posted: Sun Oct 17, 2004 8:17 am
by TNMAN
Nobody wrote:No, the axle would turn backward.
.............not to mention ...that the pinion would be starved for lubrication,
Posted: Sun Oct 17, 2004 2:51 pm
by Bob Myers
Aint that the same answer I gave you over on TRS?
Posted: Sun Oct 17, 2004 4:19 pm
by Ranger Dave
rmyers2051
what are yo runnin for a t-case??and front driveshaft
Posted: Sun Oct 17, 2004 7:20 pm
by Bob Myers
Bone stock'88 Bronco II stuff, actually it is the stuff that came from the factory on the BII, in 1988, just a mere 301,000miles ago.
I did grind a lot of material out of the face of the driveshaft where the Tcase joint would/could hit. Other than just limiting the amount of drop on the left side it works pretty good.
Posted: Mon Oct 18, 2004 12:56 am
by Ranger Dave
thanks