Page 1 of 1
How to raise my ECM
Posted: Fri Aug 20, 2004 5:45 pm
by Bronco19
Just wondering what I should do about my computer? Should I bag it or try to relocate it? Has anyone did this?
-BJ-
Posted: Fri Aug 20, 2004 7:35 pm
by DBrown
I would relocate it. by sealing it all together the temp difference could cause condensation. it is only held in by like 3 screws. just take the retainer off and move it up into the dash. right now it should be in the passenger side kick panel.
Posted: Sat Aug 21, 2004 1:34 pm
by Bronco19
Where does the fuel tank vent at? Is there anything I'm missing. I've vented my axle and T-case. My 5-speed vents at the top, so I think it's high enough for now.
Posted: Sat Aug 21, 2004 2:40 pm
by Rockcrawler
the fuel tank vents threw the charcole chanister. I put my computer up were my passenger speaker used to be.
Posted: Sat Aug 21, 2004 3:56 pm
by Bronco19
what's the charcoal canister? Is that part of the fuel pump? Also, which passenger speaker are you talking about? The six inch in the door or the rear 5x7".
Posted: Mon Aug 23, 2004 6:59 am
by PHROX
he is probably talking about the speaker on the dash.
Posted: Tue Aug 24, 2004 4:11 pm
by Rockcrawler
the chorcole chanister is up front by the radeator on the driver side. Its for smog. And it was the speaker on the dash. but putting it there would be hard becuase i took out all the vents in my truck
Posted: Mon Aug 30, 2004 11:25 am
by Bronco19
I ended up putting it behind my glove box or where it used to be. I had to separate the front and back of the GB to fit it behind there. Didn't have to cut wires or buy anything though so it worked out good.
http://www.angelfire.com/80s/broncoiis/BJ1/tech2x.html
Posted: Mon Aug 30, 2004 12:08 pm
by Rockcrawler
looks good