York oil mod
York oil mod
I finally burned up my 10 year old York so I got another and thought I would show how to change the clutch and do the "oil mod" so it does not pump so much case oil out in the air.
- Attachments
-
- carefully pry out the seal, you will be reusing it
- YorkOM6.jpg (21.12 KiB) Viewed 1174 times
-
- remove the woodruff key, cover plate bolts and plate
- YorkOM5.jpg (22.13 KiB) Viewed 1174 times
-
- pull the rest of the assembly by removing the 4 bolts
- YorkOM4.jpg (24.2 KiB) Viewed 1174 times
-
- thread in a bolt to press of the pulley, IIRC it's a 5/8-11
- YorkOM2.jpg (21.31 KiB) Viewed 1174 times
-
- remove the clutch pulley, this can be tricky since it wants to turn so I tap the 1/2 wrench with a hammer to get it free
- YorkOM1.jpg (24.97 KiB) Viewed 1174 times
Last edited by EBSTEVE on Sun Nov 18, 2007 10:06 am, edited 1 time in total.
Ranger 5.o, needing another project like Rosie O'Donnell needs another M&M.
part 2
More
- Attachments
-
- install the set screw as a plug and reassemble in reverse order, make sure to line up the woodruff key, when installed turn the clutch on to hold the pulley and do a final torque to the pulley bolt
- YorkOM10.jpg (22.03 KiB) Viewed 1165 times
-
- cover the bearing to keep as much out as possible and tap it 10-30
- YorkOM9.jpg (22.17 KiB) Viewed 1165 times
-
- you can see the small hole
- YorkOM8.jpg (20.21 KiB) Viewed 1165 times
-
- YorkOM7.jpg (25.2 KiB) Viewed 1165 times
Ranger 5.o, needing another project like Rosie O'Donnell needs another M&M.
