tcase shift inicator how do you get it to work on conerted 2

onewyr · Post by **onewyr** » Sat Nov 04, 2006 10:45 am

I am done withe the mechanical aspect of the conversion now i just need to get the indas shift indicator for the tcase to work does anyone have any ideas

Bob Myers · Post by **Bob Myers** » Sun Nov 05, 2006 9:52 am

I would presume that if you plug in the wiring harness on the top front of the Tcase, and the bulbs are intact in the dash indicator that they would light up when you go to 4hi or 4lo.
You did plug the three wire harness in on the front of the Tcase?

onewyr · Post by **onewyr** » Sun Nov 05, 2006 1:21 pm

it is a 2 wire plug and I don't have a plug under my truck mine was 2wd but I converted it I took a plug from the junk yard.
i want to know what i need to make it work

Bob Myers · Post by **Bob Myers** » Sun Nov 05, 2006 3:01 pm

I have a 90 Bronco I'm about ready to cart off to the boneyard. I'll have a look and see where the plug is, and goes to. Maybe you'll be lucky and it just plugs into the harness

Joel H · Post by **Joel H** » Mon Nov 06, 2006 6:24 am

There should be a plug on the fenderwell. It'll be a two pin plug. I don't remember the wire colors but they all seam to have this plug. It's just a matter of getting the short run of harness.

Article found here.

http://www.broncoii4x4.com/2wd-4wd/2wd- ... ersion.php