Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Rewiring Harness
Replies: 2
by
Warlock489 »
Thu Nov 04, 2004 10:55 pm
What guage wire is the main harness made out of on the 2.9. It is 18 guage?
2 Replies
1697 Views
Last post by DBrown
Sun Nov 07, 2004 5:17 am
tranny problem!!!
by
PabroncoII »
Sat Nov 06, 2004 8:41 pm
I have a 1988 B2 with a auto transmission and after I drove it about 30 miles the other day. I was putting it in to drive and the motor stalled.And...
0 Replies
2261 Views
Last post by PabroncoII
Sat Nov 06, 2004 8:41 pm
Hmmm Which locker?
Replies: 11
by
OCD4B2 »
Tue Oct 26, 2004 9:34 pm
I'm looking at getting a locker for my ford 9 and i've been looking around a lot. Detroit lockers r just too much($), and a full spool is just...
11 Replies
5004 Views
Last post by Happy_Jack
Sat Nov 06, 2004 6:32 pm
Wireing harness question?
by
Warlock489 »
Fri Nov 05, 2004 9:12 pm
I'm trying to findout what these wires go to: (86 BII, 2.9)
0 Replies
2076 Views
Last post by Warlock489
Fri Nov 05, 2004 9:12 pm
Help out my bronco
Replies: 12
by
OCD4B2 »
Wed Oct 27, 2004 10:09 pm
My bronco has been pretty messed up lately :mad2: . It's a 1990, basically stock. After I stop, fully stop, and then put on the gas, it grinds pretty...
12 Replies
5470 Views
Last post by Trigger_2001
Fri Nov 05, 2004 9:42 am
2x4 to 4x4, what do I need?
Replies: 6
by
bnmwilliams »
Thu Oct 07, 2004 3:02 pm
I am thinking of converting my 89 B2 2x4 to a 4x4 but I have a few questions. I owned an 87 B2 4x4 but let it go when I bough my 96 Explorer (mistake...
6 Replies
3028 Views
Last post by Warlock489
Thu Nov 04, 2004 11:19 pm
Onboard air
Replies: 2
by
PabroncoII »
Tue Oct 12, 2004 5:37 am
I was wondering if any one could post a wiring diagram to wire the switches on the onboard air or a link to a site that has one?I just got my first...
2 Replies
1922 Views
Last post by Warlock489
Thu Nov 04, 2004 11:00 pm
WTF???
Replies: 22
by
Phillippi »
Sat Oct 02, 2004 2:38 pm
Ok so I am starting to tear down the d44 to gut it and then cut the long side. I take off the automatic hub cover and take off the spring clip on the...
22 Replies
8750 Views
Last post by FatMan
Wed Nov 03, 2004 6:53 pm
2 Replies
2079 Views
Last post by huffs
Thu Oct 28, 2004 3:28 pm
A/C Help
Replies: 4
by
gullion_a86 »
Tue Oct 26, 2004 11:05 am
My A/C hasn't worked since I got my b2 and it's waisting space. Can someone tell me the steps on how to get the A/C out? I was also wanting to know...
4 Replies
2724 Views
Last post by gullion_a86
Thu Oct 28, 2004 11:02 am
WTF II?
Replies: 8
by
n9emz »
Mon Oct 25, 2004 10:11 pm
Spindle bearing went south a couple of months ago, and just got around to taking a look at it today. When I pulled the hub off.... :wtf: Inner...
8 Replies
4547 Views
Last post by huffs
Thu Oct 28, 2004 12:25 am
wtf does this code mean????
Replies: 1
by
huffs »
Wed Oct 27, 2004 9:50 am
my friend has a 88 with a 2.9 and a code of 95 oc something about fuel pump secondary circuit fault can anyone tell me what this is in english?? :wtf:
1 Replies
1504 Views
Last post by DBrown
Wed Oct 27, 2004 10:03 am
TTB 4wd in a 76?
Replies: 5
by
DBrown »
Tue Oct 26, 2004 1:08 pm
I posted this over at pirate also but I was looking for info on swapping a TTB D44 into my 76 F100 tow rig. anyone got any info?
5 Replies
2628 Views
Last post by DBrown
Wed Oct 27, 2004 9:45 am
7 Replies
3790 Views
Last post by DZK007
Sun Oct 24, 2004 9:14 pm
drivers seat
by
PabroncoII »
Sun Oct 24, 2004 11:10 am
Could anyone tell me what years of rangers front seats will fit a 88 B2?
0 Replies
2259 Views
Last post by PabroncoII
Sun Oct 24, 2004 11:10 am
Dipstick locations?
Replies: 2
by
TNMAN »
Sun Oct 17, 2004 8:23 am
I am putting in another engine. The engine that I am removing has the dipstick in the lower part of the drvr side eng block.This engine has the...
2 Replies
1562 Views
Last post by TNMAN
Sun Oct 24, 2004 4:33 am
0 Replies
2267 Views
Last post by Trigger_2001
Fri Oct 22, 2004 9:58 am
D-20 T-case, emergency brake kit....
Replies: 15
by
Bob »
Mon Oct 18, 2004 7:15 pm
ok SICK of the stock emergency brake cable problems, and rear brake problems. Time to dump the drums for disk brakes.
15 Replies
8348 Views
Last post by DBrown
Thu Oct 21, 2004 7:04 pm
Distributor problems
Replies: 9
by
gullion_a86 »
Mon Oct 18, 2004 5:09 pm
Ok first off I recently got a 85' b2 and the only thing that kept the engine from running was that the distributor had been distroyed (literally)....
9 Replies
4541 Views
Last post by DBrown
Wed Oct 20, 2004 9:01 pm
prolly a stupid ??? but
Replies: 6
by
Ranger Dave »
Sun Oct 17, 2004 7:14 am
here goes
6 Replies
4210 Views
Last post by Ranger Dave
Mon Oct 18, 2004 12:56 am
Front buckets
Replies: 3
by
Phillippi »
Sat Oct 16, 2004 12:36 am
Hey Matt, I was looking at your site and noticed on your D44 swap page you keep the B2 upper coil spring buckets. How are they? Should I use the FS...
3 Replies
1948 Views
Last post by broncoo
Sat Oct 16, 2004 9:12 pm
Propane?
Replies: 9
by
TNMAN »
Tue Oct 12, 2004 7:05 pm
I am about to drop in another 302 in the Bro3. I can get all the stuff to make it run on propane dirt cheap. I ride with a couple guys that use it...
9 Replies
4156 Views
Last post by TNMAN
Thu Oct 14, 2004 2:55 am
1 Replies
1446 Views
Last post by Nobody
Wed Oct 13, 2004 1:09 pm
B2 Stock gears
Replies: 9
by
OCD4B2 »
Mon Oct 11, 2004 7:44 pm
OK, i have to replace my rear ring and pinion do to a loss of traction and a hard grinding noise....nope doesn't sound good. But I need to know what...
9 Replies
7953 Views
Last post by OCD4B2
Wed Oct 13, 2004 11:23 am
transmission swap
Replies: 4
by
bowman »
Tue Oct 12, 2004 6:59 am
Just stumbled onto this site and was wondering if someone could help me out. I swapped out an auto trans. for a manual in my 87 BII .Now it won't...
4 Replies
2065 Views
Last post by bowman
Tue Oct 12, 2004 8:43 am
the new b2 project
Replies: 10
by
jeepsubmarine »
Fri Oct 08, 2004 9:35 am
well im starting a new b2, i picked up the new b2 for $250(the frame and body& suspension and axles). i also bought a 302, c-6 and 205tcase for $500...
10 Replies
6135 Views
Last post by DBrown
Mon Oct 11, 2004 8:19 pm
alt....
Replies: 5
by
wilber »
Thu Oct 07, 2004 6:17 pm
b2 isnt chargin, dont know much details about it, some year crown vic motor i think, fuel injected, serpentine belt alt,
5 Replies
2678 Views
Last post by wilber
Fri Oct 08, 2004 5:01 pm
another save question
Replies: 2
by
DBrown »
Thu Oct 07, 2004 4:29 pm
I know this topic is getting old but I went to autozone today to find out about a slave from the 75 land cruiser.....and he asked me if it was 4x4 or...
2 Replies
1547 Views
Last post by DBrown
Thu Oct 07, 2004 6:13 pm
which slave?
Replies: 3
by
OCD4B2 »
Sun Oct 03, 2004 4:32 pm
:confused: Ok i found the slave cylinders on the internet and wondered which one should i get for my application? I'm gonna be runnin a 302 with an...
3 Replies
1747 Views
Last post by wilber
Thu Oct 07, 2004 6:09 pm
chop top
Replies: 6
by
jeepsubmarine »
Tue Oct 05, 2004 7:57 pm
i've seen alot of pics of chop tops but havnt seen anybody with soft tops or nothin, are they out there? if so who makes em?
6 Replies
5378 Views
Last post by In the Zone
Thu Oct 07, 2004 4:46 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum