Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
oil pump screen
Replies: 2
by
garagedude »
Tue Nov 06, 2007 4:14 pm
why are the oil pump screens so expensive. I've never seen one. should I be able to use my old one when I rebuild my motor(84 2.8)
2 Replies
1849 Views
Last post by garagedude
Tue Nov 06, 2007 5:10 pm
0 Replies
1246 Views
Last post by amberbrush
Mon Nov 05, 2007 7:24 am
I need stuff
Replies: 8
by
garagedude »
Fri Oct 26, 2007 5:13 pm
Where can I find a set of headers, a mallory dist for an 84 BII 4x4? I can't seem to find any??
8 Replies
3506 Views
Last post by ranger5.0
Sun Nov 04, 2007 8:13 pm
2.8 questions
Replies: 7
by
garagedude »
Tue Oct 30, 2007 6:41 pm
I received my short block today. I've overhauled atleast 200 sbc but never a 2.8. Are there any weird things that I could miss? special oil passages?...
7 Replies
3047 Views
Last post by ranger5.0
Sun Nov 04, 2007 8:01 pm
Cooling woes continue
Replies: 10
by
yoyodyne »
Sat Oct 27, 2007 5:10 pm
I swear..no car I ever had gave me fits with the cooling system like this Bronco has. 1984 model. Taking too long to warm up..no thermostat. Went to...
10 Replies
5190 Views
Last post by Ruffinit
Sun Nov 04, 2007 7:00 am
Low Fuel indicator light ?
Replies: 5
by
yoyodyne »
Tue Oct 02, 2007 8:22 pm
What sensor turns this light on? The little yellow one in the panel on the console. Truck was on emply when we bought it, put in 3/4 of a tank on the...
5 Replies
3012 Views
Last post by Ruffinit
Fri Nov 02, 2007 1:52 pm
Nerf Bars
Replies: 2
by
poppy79424 »
Tue Oct 30, 2007 5:42 am
Does anyone know if the same nerf bars will fit 2wd and 4wd 86 Bronco II ? Im also looking for black grille gaurd for my 86 B2.
2 Replies
1076 Views
Last post by poppy79424
Thu Nov 01, 2007 4:56 am
2 Replies
1645 Views
Last post by steiner_5000
Wed Oct 31, 2007 2:01 pm
Cold Start Idle Adjust?
Replies: 1
by
CraigK »
Tue Oct 30, 2007 2:12 am
I’m driving my’87 B2 more this fall than for the past few years, and a problem I’ve had is getting more annoying with the cold. This vehicle has...
1 Replies
1250 Views
Last post by Nobody
Wed Oct 31, 2007 9:44 am
Testing the TPS
Replies: 1
by
steiner_5000 »
Mon Oct 29, 2007 7:51 am
How can I test my throttle postion sensor to see if its bad. Also how can I test the o2 sensor. Truck still runs kinda funky and was just going...
1 Replies
1219 Views
Last post by Nobody
Wed Oct 31, 2007 9:41 am
87 rearend swap help quick!
by
90b2GT »
Sun Oct 28, 2007 4:45 pm
i have a 90 b2 and a 87 f150 8.8 inch rearend im bidding on a set of new 31 spline axles and 355 gears for a 95 f150 rearend and have found a locker...
0 Replies
1148 Views
Last post by 90b2GT
Sun Oct 28, 2007 4:45 pm
fuel injection question
Replies: 2
by
armonster24 »
Fri Oct 26, 2007 8:39 pm
hi im running a 2.9 liter bronco engine but the stock efi intake is too high to meet my hood clearance is there anyway to upgrade the efi system or...
2 Replies
1145 Views
Last post by armonster24
Sat Oct 27, 2007 10:21 am
Replacing the oil sending unit
Replies: 1
by
spot »
Tue Oct 23, 2007 6:51 am
Has anyone replaced/removed the oil sending unit on a 2.9 while everything was still assembled? Simple as replacing a spark plug but how the hell do...
1 Replies
1045 Views
Last post by 1highlander
Fri Oct 26, 2007 4:33 pm
2.8 short block
by
garagedude »
Wed Oct 24, 2007 4:22 am
How much is a re-manufactured short block worth? Enginesdirect has one and I'm interested..
0 Replies
1204 Views
Last post by garagedude
Wed Oct 24, 2007 4:22 am
Thermostat question
Replies: 4
by
yoyodyne »
Sun Oct 21, 2007 2:28 pm
Now that is getting colder, I noticed the truck was not warming up very fast. Pulled off the thermostat housing, sure enough, there was no thermostat...
4 Replies
2104 Views
Last post by Ruffinit
Tue Oct 23, 2007 6:29 am
Heater Fan
Replies: 4
by
steiner_5000 »
Wed Oct 10, 2007 7:51 am
Well its starting to get cold here in Iowa so I started up my bronco and turns the heat on but nothing happend. The heater fan doesnt' atcually kick...
4 Replies
2242 Views
Last post by Ruffinit
Mon Oct 22, 2007 8:24 am
14 Replies
6515 Views
Last post by mechjames
Sun Oct 21, 2007 6:48 pm
Bucking Bronco
by
Paul »
Sun Oct 21, 2007 4:13 pm
Well I know most of you have heard of the Dreaded Bucking Bronco, due to clutch problems, well i found that the GKN style drive shaft in the rear...
0 Replies
1577 Views
Last post by Paul
Sun Oct 21, 2007 4:13 pm
Different wheels/rims
Replies: 2
by
cdmiller »
Sat Oct 20, 2007 9:29 am
I have a 1990 B2 with the automatic locking hubs for 4X4.The rims on it now are not factory or very nice looking for that matter,so my question is...
2 Replies
1981 Views
Last post by Paul
Sun Oct 21, 2007 3:52 pm
F-150 Springs?
Replies: 2
by
bluebroncoman »
Tue Oct 16, 2007 9:53 pm
hey i just picked up an 88 bronco 2 for $150 and have a junked 89 f-150 and i was wondering if the coils and leaves were swapped if id pick up some...
2 Replies
1397 Views
Last post by Joel H
Sat Oct 20, 2007 7:42 pm
Black Chrome Lug Nuts
by
CraigK »
Fri Oct 19, 2007 1:03 pm
Just thought I'd share this . . .
0 Replies
1327 Views
Last post by CraigK
Fri Oct 19, 2007 1:03 pm
A couple 4.0 swap questions
Replies: 7
by
amberbrush »
Fri Oct 05, 2007 7:25 am
O.k., a lot of you probley know I ended up putting another 2.9L engine in my 1988 Bronco II this summer because we couldn't diagnose the power...
7 Replies
3807 Views
Last post by Paul
Mon Oct 15, 2007 4:11 pm
kaufmann products
Replies: 1
by
90b2GT »
Sun Oct 14, 2007 4:08 pm
:wtf: i hear so much about these kaufmann motor mounts and headers and all but i cant find any part numbers or anything like that and the web site...
1 Replies
951 Views
Last post by Nobody
Sun Oct 14, 2007 10:18 pm
88 B2 no spark no fuel no starting
Replies: 15
by
Syko »
Sat Oct 06, 2007 6:00 pm
I figure its the TFI but dont know what i need to get the old one off i have a new one waiting to get put on... i just need some help anyone know how...
15 Replies
7418 Views
Last post by Paul
Sun Oct 14, 2007 4:57 pm
36 Replies
19815 Views
Last post by johnnyrotten
Sun Oct 14, 2007 8:04 am
The Perfect Project - 3:1 (4.0 liter)
Replies: 8
by
Ruffinit »
Mon Oct 08, 2007 8:39 am
First off I want to say that what Amberbrush is asking is one of my own questions. I will be making this 4.0 swap next week and my biggest question...
8 Replies
3774 Views
Last post by Joel H
Fri Oct 12, 2007 2:30 pm
3 Replies
1649 Views
Last post by bower100
Wed Oct 10, 2007 8:37 pm
Bronco II Slow shift to 4wd.
by
Al »
Wed Oct 10, 2007 4:22 am
I have a 90 Bronco II thats been sitting in the shop waiting its turn to get a new clutch for a year. Now that I put it in I seem to remember that...
0 Replies
1250 Views
Last post by Al
Wed Oct 10, 2007 4:22 am
15 Replies
6688 Views
Last post by Nomad84
Tue Oct 09, 2007 10:22 pm
02 Sensor
Replies: 2
by
Willie Two »
Mon Oct 08, 2007 8:46 pm
How can I test the O2 sensor on my 2.8 / 84 Bronco. Does it change in resistance when it is working properly or is there a voltage change I can...
2 Replies
1577 Views
Last post by ranger5.0
Tue Oct 09, 2007 8:56 am
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum