BroncoII4x4.com

I also ended up changing polarity of the wires to get the motor to turn in the correct direction. After being stumped on this for awhile I finally just bought a new motor. When i hooked it up right off the bat it was turning in the wrong direction. This suprised me since I had to change the wires ...

i'm going to check again. The biggest problem is not being able to see how the gears meetup and having to put the motor and bolts in primaraly by feel since it is inside the door.

I have a 1990 bronco II and I just replaced the Gear in my passenger side power window motor. When i pug the motor in while holding it in my hands it operates in both directions. When i install it I press the up button and it makes the window go down and when i press the down button it acts like its ...

I have a 1990 bronco II 2.9 4x4. Recently I just replaced all my fuel injectors to increase my fuel performance. After i put everything back together I noticed that my temperature gauge no longer works it stays pegged at below zero. Before the injector change it worked fine. I have since replaced ...

I have a 1990 Bronco II 5 speed manual with a 2.9liter engine. My temperature gauge stopped work the other day and while I was driving around town (with the A/C on) I started seeing white smoke out from under the hood. After parking it and checking on it later the engine is fine. No more smoke. I am ...

I have a 90 bronco II that has the push button 4x4. I have been messing around with the 4x4 for awhile. When it first died I knew it was the motor and tried to clean it but that didn't work. At that time when i pressed the button on the module the light would flash several times which I was told was ...

I have a old 84 broncoII with the manual case will that fit right up to my mazda transmission? and will the 90 driveshaft work?

I have a 90 bronco II with automatic 4x4 and auto locking hubs. I want to change from automatic to a manual transfer case. Can i convert my automatic transfer case to a manual? or do I have to install a different transfer case already setup to be manual

I just removed my 4x shift motor on my 90 bronco II cleaned the contacts and reinstalled it. Now my 4 Hi works every time but my 4 low sometimes it works and other times it acts like the transmission is in neutral. Is this a mounting issue?

:hmmm: I have a 1990 Bronco II 2.9 4x4 and recently my rear antilock and brake lights are on all the time. I have done some reasearch and checked that my brake fluid level is good, and the brake level float works. I have also pulled the codes by shorting the diagnostic connector by the e-brake to ...

I didn't check the transmission shaft for the main input bearing. I know I will have to remove the transmission again to check this. Is there anything else I should check? How hard is it to replace the main input bearing, and does it require any special tools?

I have a 1990 Bronco II with a 5 speed manual transmission. Just last week I started hearing a rattling noise. It goes away when I press the clutch pedal down. It was present when in all gears and when it is in neutral. I had assumed it was the throw-out bearing. Just this weekend I replaced the ...

I have a 1990 bronco II. Recently I have been having my ebrake and antilock warning lights come on I don't know why. When they turn on they will stay that way until I turn off the ignition and then turning it back on. My e brake is not on and before I have only had the antilock come on when I start ...

Does anyone else know anything about this?

I have a 1993 Ford Explorer. Recently I have been having my headlights blink/flicker on and off intermittnetly. The dash lights stay stedy. I have checked the fuse connections and the connectors to the lights themselves, but it all looks good. Does anyone have any suggestions??