BroncoII4x4.com

playday, check out www.faithwheelers.com for info

I used a gates #20923 (napa #7648)
One hose, with no kinks or funny bends.

Thats weird. Iv never heard of a inertia switch, just shutting off without impact. You said you have exhaust leaks....Any leaks near the inertia switch? MAYBE if the switch gets hot they shut off to. I know chevys will kill the fuel pump with a bad OP censor. Actually there in case you get to low of ...

Looks like close to 10 for me....
And no photos :(
Maybe thats a good thing, I got it from my Mom, with whitewalls, and running boards

The D-300 t-case is for a jeep or something with the axle gears on the right side. You can use one, but will require a straight axle from something kinda to "chevy like" hehe A D-20 will work, but you will need a tranny with something a adapter is avalible for. You will also need drivelines, and a ...

no driveline brake... Have added a steering brake, but it locked up the right side, and I had to send it back for a replacement. The D20 is in, "J" shift The twin stick I built. Anyone who says the 1350 T-case will hold up to a V8 is right. Anyone who says the tranny output shaft into the 1350 will ...

heres a couple pics...
The "Brown haze" color is a better match for real, but with the flash, and taking the pics in near dark...
I would have ordered the same colors if I had ordered them, but without the black, although with black harnesses, it will be fine...

Try and get that coast side off the edge of the tooth.

Yeap, there setup for 5 point harnesses, and I will see about a pic and post tonight. Prices...they when up and I got them from a shop whos had then sitting around awile. Evedently knowone wanted the colors I needed,so he never sold them, so I got them for his old cost...or so he says. 2 seats and a ...

If I remember right, the spanner socket for your front hubs fits. I may be wrong on the socket though, Iv done several 9" setups, and we have several hub tools, but Im 99% sure the one you have (or should) will work. As far as preload on the carrier bearings, its kinda a feel thing, but the torque ...

Well I FINALLY got my set of Mastercraft "Rubicon" seats. Guess what? Direct bolt-in! ('84 BII) The left side runners I had to drill out the metric holes, for 3/8" bolts, but there SO close Im thinking you can run the bolts through with a wrench. or 2 strokes with a round file. Its so close, that ...

OK.. I just got off the phone. The basic kit cost $269, BUT the kit avalible REQUIRES the 32 spline output shaft. Aprox $350 AND you need the $99 flange, AND 1350 driveline, AND...get the point? The artical I read was pre production, and hasnt gone into production, and probibly wont. The kits IS ...

I have and still may go that way, but the gear reduction from the axles, and the idea if 4 wheel e-brake(in 4x4) Plus the "Neet" factor...hehe Iv seen a kit for around $200, without the heavy duty output shaft, but it has been a few years, and I beleave this is this kit. No pricing online, but Im ...

Yippy! Thats the ticket! Who, where, and how much? Iv seen a kit someware in the $200 range, but thats not including the rear output yoke, but they said they modify the stock unit for FREE if you send it to them. Not like I cant to this at work. Its this or built the whole setup, but I do it ...