Page 1 of 1

correct pinion angle

Posted: Thu Mar 10, 2005 10:00 pm
by NMB2
ok im doing my 8" axle swap and ive just got the perches welded on...the only thing i did take into consideration is the lift shackles, i setup the pinion/d-shaft pointing straight at eachother so at full hang they are straight. then i put in the 2" lift shackles and it set it off just a little bit...it'll go back to just about straight i imagine once the truck sits on itself. is that pinion angle alright or am i going to break something?