Page 1 of 1

Interior....

Posted: Thu Dec 30, 2004 10:49 pm
by Arrival
I've been looking for 2 things and can't seem to find them. Then again i've have my bronco for a VERY short time (i can't say i'm a experienced BII owner at one month) and i'm probably lookin in the wrong direction.

Both things i'm looking for are pretty simple and depending on which one I find first it will probably change how i use them. First i'm looking for diamond plating for the interior. I haven't decided if i want to do floor plates for the fronts seats or if i want to cover the cargo area with it. But one way or another i want some carpet to cut down on noise. The second thing i'm looking for is possibly premolded carpeting. I rather hate the old nasty worked over red carpet in my BII so i'm looking for a change. I figure i can skip changing out the seats by just adding some solid color seat covers. In the month i've had my BII i've ordered quite a few mods but haven't had the time to bolt them on. Once I do I'll try to throw a pic up. Thanks for the help guys!
:D

Posted: Thu Dec 30, 2004 11:02 pm
by Nobody
Check out JC Whitney for carpet kits

http://www.jcwhitney.com/autoparts/Prod ... pId-403653

Posted: Sat Jan 01, 2005 8:34 pm
by foxfan
i have brand new in the box vinyl flooring w/ jute for a BII including cargo area.

i think it was like $250, i'll have to check. anyway i'll sell for less than new whatever a good deal is.

i won't use it, because i'm running bare metal less mildew and i'm not using the BII body anymore either.

Posted: Sat Jan 01, 2005 9:14 pm
by DZK007
Check ebay as well. I have seen molded sets of new carpets for under $200 for the whole truck.

Posted: Mon Jan 03, 2005 8:48 pm
by 85ranger4x4
www.lmctruck.com

They have good ranger stuff, maybe something for the BII

Posted: Tue Jan 11, 2005 3:39 am
by marinebroncoii
I also just noticed today that James Duff has started to carry premolded carpet and vinyl in most of the stock colors. As stated by others LMC, JC Whitney and E-bay are good places to look too. As for the diamond plate I would just go buy a full sheet and cut and bend it to fit where ever you want it; 1/8 or 3/16 inch is easy to work with.