BroncoII4x4.com

I have an 86 Bronco II and im interested in building or using exsisting vehicle parts to get 2-4 in of lift any ideas or suggestions??

For cheap 2in lift, get the coils and leaves from an '91-94 4 door Exploder

Thanks i was gonna use xj springs but keeping it all Ford sounds good do the leafs bolt right up? and what about alignment? i know i will need camber bushings

Have to flip the centering bolt on the leaf springs, Exploders are spring under B2's are spring over. Other than that make sure your shocks are long enough to not limit your suspension travel

If trying for more than 2in lift it will require drop brackets for yhe front axle.

Is it correct that he will need camber bushings?

I did not need to when I did mine, but every Bronco is a 'lil different.

Thanks, this will probably be my lift, at least for a little while.