BroncoII4x4.com

Posted: **Tue Apr 26, 2011 4:06 pm**

Hi all....

I'm new here but not new to Bronco's!
I have an 88 Bronco II with an AL4D tranny.
Just had the tranny go out on me so I bought another used one. My Bronco II is a FLOOR shift. The one I am putting in is from a TREE shift Bronco II. I notice the linkage connector at the tranny is slightly different. Can I swap the linkage connectors out between the 2 transmissions? It looks like if I pull off the pan I should be able to get to it from the inside?

Posted: **Wed Apr 27, 2011 3:58 am**

good luck with a USED a4ld,hope it has a warrenty. i guess tree shift you really meen column shift? ya have to pull the pan and VB.

Posted: **Wed Apr 27, 2011 5:32 pm**

I got to drive the truck first then helped him pull it out.
Tranny looked real clean for coming out of an 89. Looks to have been replaced. At $250.00 kinda hard to pass.
I wanted to put in a manual but we need to get my son up and going. I plan on doing a manual conversio later.

By VB I assume you mean valve body. Any trick to that?

Posted: **Thu Apr 28, 2011 3:58 am**

i dont play with A4LD's, i junk um. the valve body should unbolt just like all the rest.

BroncoII4x4.com

Tranny from tree shift into Bronco with floor shift

Tranny from tree shift into Bronco with floor shift

Re: Tranny from tree shift into Bronco with floor shift

Re: Tranny from tree shift into Bronco with floor shift

Re: Tranny from tree shift into Bronco with floor shift