Page 1 of 1
Hello, I got a vacuum line here that needs to go somewhere??
Posted: Sun Sep 26, 2010 9:21 pm
by mitchwood
Check this picture out I dont know how it turned out but I circled the line and pointed to the end of it... I dont know where this end should go to?? If someone could help me that would be greatly appreciated and I'd give you an electronic beer...

there you go.. I got some in the fridge here.... but... well, go buy one and then drink it for me and pretend i bought you one because THESE VACUUM LINES ARE STARTING TO PISS ME OFF. : )
thanks guys! I appreciate your time...
I've looked and cannot get my hands on any good vacuum line diagrams for my 2.9L 1987 ford bronco II. 4x4
thanks again.
Re: Hello, I got a vacuum line here that needs to go somewhe
Posted: Mon Sep 27, 2010 6:49 pm
by drofman
I think that was a silicone hose that went under the t/b. I may be wrong
Re: Hello, I got a vacuum line here that needs to go somewhe
Posted: Wed Sep 29, 2010 5:07 pm
by kgervais
Mitchwood,
That line goes to the underside of the throttlebody between the two larger diameter lines.