Page 1 of 1
Rear Axle Swap
Posted: Sat Aug 21, 2010 2:36 pm
by gdees
I have a 1988 Bronco 2 and the driver side rear axle shaft is bent. I have a 1990 Bronco 2 that is without a motor. Can I swap the whole rear axle assembly without further repairs, issues or problem? Thanks for any advise or opinion.
Re: Rear Axle Swap
Posted: Sun Aug 22, 2010 6:21 am
by Ranger Dave
yup. can also use a ranger dr.side axel
Re: Rear Axle Swap
Posted: Sun Aug 22, 2010 8:25 pm
by gdees
Thanks. All done. Went as smooth as a babies butt.
Re: Rear Axle Swap
Posted: Sun Aug 29, 2010 7:34 pm
by bronco jim
Hope the gearing was the same