Page 1 of 1
Bronco ii lift kit questions
Posted: Tue Apr 13, 2010 11:13 pm
by BroncoKen
Hey all. I am experienced with my bronco but not with lift kits. I was wondering I am looking at a 4" Rough country suspension lift with new leaf springs. If I do the recommened explorer rear end swap will the same bronco 2 lift kit work? thanks
Re: Bronco ii lift kit questions
Posted: Wed Apr 14, 2010 1:02 am
by Ranger Dave
yup
Re: Bronco ii lift kit questions
Posted: Wed Apr 14, 2010 7:55 am
by joeyy
Now i know that a 91-93 explorer is the best fit, but how much actual fabrication is needed to swap out the axles, do I have to do any cutting/welding? or can I just throw them under there and use the existing mounts?
Re: Bronco ii lift kit questions
Posted: Wed Apr 14, 2010 9:01 am
by BroncoKen
Thanks Ranger Dave. Appreciate the help.
Re: Bronco ii lift kit questions
Posted: Wed Apr 14, 2010 3:11 pm
by Ranger Dave
hang on, youll need the U bolts and spring plate for the xplorer axel. bigger tubes. and move the spring pads on top
Re: Bronco ii lift kit questions
Posted: Wed Apr 14, 2010 9:54 pm
by BroncoKen
so as long as i get the spring plates and the stock ubolts i will be ok?
Re: Bronco ii lift kit questions
Posted: Wed Apr 14, 2010 9:57 pm
by BroncoKen
i also have another question. how wide are the stock b2 rims? How wide of a tire will be safe on them?
Re: Bronco ii lift kit questions
Posted: Thu Apr 15, 2010 4:18 am
by Ranger Dave
BroncoKen wrote:so as long as i get the spring plates and the stock ubolts i will be ok?
yup
also need the shock mounts from the 7.5
8.8 in my ranger
my ranger
http://rangerdave.freeforums.org/the-tractor-t21.html