BroncoII4x4.com

ok i was taking the manifolds off and a bunch of the bolts broke off in the heads. how do i remove them? thanks

drill them out with a bit one size smaller then the olt it self then re-thread the hole or you can buy an easyout set... they go for roughly $25- $30

thanks ill try that, i was going to heat them up and try to take em out with some visegrips but with the heads still on the motor . ill try your way first.

chucknti wrote:thanks ill try that, i was going to heat them up and try to take em out with some visegrips but with the heads still on the motor . ill try your way first.

Before you attempt to unscrew the bolts after you drill a hole for the ez out, Be sure to soak the bolt area with a good penetrating oil. I found Pb Blaster works best for me.

x2