Page 1 of 1
89 b2 drive shaft
Posted: Wed Sep 03, 2008 8:26 pm
by branger
i bought a 89 bronco2 with a broken rear driveshaft, it looks like a "tulip" style, so i went to the junkyard and got a drive shaft out of another b2 and it was different, it had u joints, and a cv joint, i would like to use this drive shaft but only one end bolts up. What should i do?
Re: 89 b2 drive shaft
Posted: Thu Sep 04, 2008 2:14 am
by onewyr
sounds like you bought an old old one some of the older b2s had a yoke on the back of the transfercase which if i am not mistaken you can swap yokes on the transfer case
Re: 89 b2 drive shaft
Posted: Fri Sep 12, 2008 10:14 am
by slamball
If i remember correctly there is 2 styles of driveshaft in bronco2s. My haynes manual has both in it, although I can't find it
.