1350 front output shaft loose..What a do?
Posted: Thu Aug 07, 2008 2:45 pm
When I grab the yoke it has about 1/4 inch of play side to side. The ujoint attached to the yoke is also trashed and needs replacement, which may or may not have been the culprit of this play that I’m seeing in the front output yoke. I have zero experience with the 1350 tcase... Has this happened to anybody else and what kind of fix does this entail? I'm hoping its just a stretched out chain. If the case if f-ed then maybe I’ll try a 1350/1354 doubler as this is a green stickered off road rig only.
Application; 84 b2 2.8l- 4speed manual tranny, the only numbers or letters I could find on the case of the tranny was R4
The t-case works and engages fairly smoothly and I’m able to hit all gears while in 4 high and low. I'm tempted to just leave it until it breaks. I've still put virtually nothing into this rig and I can't seem to kill it no matter how hard I beat on it.
$400 as is
Shot with DSC-T1 at 2008-07-10
Application; 84 b2 2.8l- 4speed manual tranny, the only numbers or letters I could find on the case of the tranny was R4
The t-case works and engages fairly smoothly and I’m able to hit all gears while in 4 high and low. I'm tempted to just leave it until it breaks. I've still put virtually nothing into this rig and I can't seem to kill it no matter how hard I beat on it.
$400 as is
Shot with DSC-T1 at 2008-07-10