BroncoII4x4.com

Posted: **Fri Apr 25, 2008 5:29 am**

I have my rear done, all the brake lines done, etc.

What's missing?

My drag link and the rest of my steering.

I do have everything off the stock EB.

However, I've been doing research and I'm finding out it may not work?

Can't I just get a drag link made up and be done with it or do I have to go with the high steer set up?

Posted: **Fri Apr 25, 2008 7:36 am**

Try is and see if it will work or not. Your biggest problem is going to be the length. I used the stock drag link of of my BII as a lemp. fix. Now I made my own hi-steer and I used crom-oly rod ends.

Posted: **Fri Apr 25, 2008 9:38 am**

Any part #'s for the tie rod ends?

Posted: **Fri Apr 25, 2008 2:24 pm**

Can any one confirm these part #'s for a hi steer set-up?

Hopefully I did enough research and ordered the right stuff!

TRE - ES2233L and ES2234R

DLE - ES2026R and ES2027L

I understand I will have to be doing some fabrication once I pick these up tomorrow.

The one thing I couldn't find in the short amount of time I had was the size of DOM tubing that I need. Length / I.D. / O.D.

Thanks in advance!

BroncoII4x4.com

Well... I thought I was almost done.

Well... I thought I was almost done.

Re: Well... I thought I was almost done.

Re: Well... I thought I was almost done.

Re: Well... I thought I was almost done.