Page 1 of 1
transfer case mount
Posted: Thu Feb 28, 2008 2:16 pm
by onewontwo
ive looked through the forum and posted once before and cant find an answer.... what do i do with my stock mount during the d44 swap process... my mount goes tight underneath the frame and wraps the outside of the frame right where my radius arm bracket will be mounting... please help i plan on doing this over the weekend
Posted: Thu Feb 28, 2008 8:16 pm
by Phillippi
You might have to fab up one. It shouldnt be too difficult if you have the proper tools.
Posted: Thu Feb 28, 2008 8:45 pm
by Nobody
My 84 BroncoII's crossmember was on the inside of the frame. Only required a hole to be drilled in it. I have a few friends that just made their own crossmembers. Should be pretty easy to fabricate.
Posted: Sat Mar 08, 2008 8:04 am
by Bob Myers
I made a new crossmember to alleviate that, mounted it on the radius arm pads. Could have possibly made something simpler or modded a factory unit but I just don't think that way.
Posted: Sat Mar 08, 2008 5:09 pm
by onewontwo
thats the way i was going to go...