BroncoII4x4.com

Posted: **Fri Nov 16, 2007 6:41 am**

Here is the LED flipped around. Going to trim the grill some and bond in an aluminum mounting panel behind it. The light will be sunk into the grill about another 1 inch yet.

Posted: **Wed Feb 20, 2008 7:14 pm**

After looking at it more I couldn't sink the lights in without making a funky rear panel to house the lights. I just made a plate to have the lights sit in the groove.

Posted: **Sun Feb 24, 2008 11:10 am**

Posted: **Sun Feb 24, 2008 11:40 am**

Looks good. Too bad you have to cover it up.

Now if you could make a metal replica. You would be in business. Seems everytime I put on a new plastic grill, it would last about a week.

Posted: **Sun Feb 24, 2008 1:20 pm**

Nobody wrote:Looks good. Too bad you have to cover it up.

Now if you could make a metal replica. You would be in business. Seems everytime I put on a new plastic grill, it would last about a week.

It's coverd temporarily. I should pull the cover off and see what it looks like.

I think I'm going to keep the white center look.

Posted: **Sun Feb 24, 2008 1:22 pm**

How cold is it there?

Posted: **Sun Feb 24, 2008 5:44 pm**

Nobody wrote:How cold is it there?

Last 4 weeks was average -30°C.

Posted: **Mon Feb 25, 2008 7:28 pm**

Without the winter front.

Posted: **Mon Feb 25, 2008 8:02 pm**

I just noticed how you painted the roof white, similar to they typical EB scheme. Kinda cool.

Posted: **Tue Feb 26, 2008 5:46 am**

I was lazy and didn't put the winter front back on. Lets Just say it was a mite chilly on the way to work today.

Normally I can run the truck with the e-fan off on the highway and it gets a bit over 140°. Today it didn't even make it to 120°

So it'll go back on today when i get home.

BroncoII4x4.com

How Far can I take it???

How Far can I take it???