Dana 44 R&P
Posted: Mon Aug 02, 2004 6:36 pm
Are all d44 R&Ps the same? Or are the cut different? This dude doesnt say and hasnt responded to my question yet. http://cgi.ebay.com/ebaymotors/ws/eBayI ... 7913752941
My gears
Page 1 of 1
Posted: Mon Aug 02, 2004 8:55 pm
No, on a high pinion axle, the gears are cut in the reverse direction. Assuming it's the actual gears in the picture, they are low pinion gears.
My gears
My gears
Posted: Tue Aug 03, 2004 8:37 am
you also need to make sure you have the right carrier too. the carrier for a 3.50 and a 4.10 or higher are different.
Re: Dana 44 R&P
Posted: Sat Aug 07, 2004 2:47 pm
Philipi, I'm going to have a set of 4.09 and a tracloc for d44, and a set of 4.10 for a 9" for sale very soon. Very, very soon if you want them.Phillippi wrote:Are all d44 R&Ps the same? Or are the cut different? This dude doesnt say and hasnt responded to my question yet. http://cgi.ebay.com/ebaymotors/ws/eBayI ... 7913752941
Posted: Sat Aug 07, 2004 4:25 pm
4.10 is a good ratio for a V8 and 33's.
Posted: Sat Aug 07, 2004 4:43 pm
how much will they be for sale for?
Posted: Sun Aug 08, 2004 7:43 pm
PM sentPhillippi wrote:how much will they be for sale for?