Page 1 of 1
Dana 44 swap-Trackbar Bracket
Posted: Wed Aug 15, 2007 9:14 pm
by Trav
Hey,i just traded my snowmobile for a 86 Bronco II with a 302 and it has a dana 44 front swap (halfway done and a ford 9" in the rear.Anyways my question is does anyone have any instructions or a diagram/pic of the trackbar bracket you used with your swap.I need to make one for my new ride.Any info is greatly appreciated. Trav
Posted: Sat Aug 18, 2007 6:13 am
by Bob Myers
This is an Early Bronco unit, I bought it off Ebay cheaper than I could make my own, and welded it to a plate, which is much larger than the mount(not shown here, this was just the initial mockup) and welded that to the frame rail. I also used a piece of flat stock to go over to the engine cross member from the bolt hole. and weld on for extra support
If you want better pictures I can take them for you but it'll be next week before I can.