Page 1 of 1
Explorer body parts VS Bronco II Body parts
Posted: Tue Aug 14, 2007 7:07 am
by greenmachine89
I was hoping if anyone knew if a Explorer grill, head lights, hood, front core suppport, would fit on a BII? I have an 89 and was needing the front redone.
Re: Explorer body parts VS Bronco II Body parts
Posted: Tue Aug 14, 2007 9:15 am
by TRUNK_MONKEY
greenmachine89 wrote:I was hoping if anyone knew if a Explorer grill, head lights, hood, front core suppport, would fit on a BII? I have an 89 and was needing the front redone.
the front sheetmetal is the same.just make sure you have all of one or the other concerning lights grills etc. rad support should be the same as well.
just try to keep the donor vehicle as close to your year as possible.
scott
Posted: Tue Aug 14, 2007 6:58 pm
by greenmachine89
Good deal! I was looking at a 91 Xploder today and the front end seemed to match up! I hope to get the engine as well.
Posted: Mon Aug 20, 2007 8:51 am
by onewyr
the sheetmetal is not the same from explorer to broncoII look at the lateral body line that is in the bronco it doesn't exist in the explorer. the grill and lights may work but and maybe the core support but not the sheetmetal
Posted: Mon Aug 20, 2007 3:36 pm
by greenmachine89
Thats good cause I needed lights, grill, hood, and core support
Posted: Tue Aug 21, 2007 9:59 am
by TRUNK_MONKEY
onewyr wrote:the sheetmetal is not the same from explorer to broncoII look at the lateral body line that is in the bronco it doesn't exist in the explorer. the grill and lights may work but and maybe the core support but not the sheetmetal
crap! you are totally right,my bad.the fenders wont be the same,but the hood and grille etc are good to go.
sorry about that,i totally forgot that MINOR detail!LOL
Posted: Wed Aug 22, 2007 6:18 pm
by onewyr
hood is not the same either measure the width of the hoods I am pretty sure they are different