Page 1 of 1
Front disc removal
Posted: Wed Jul 04, 2007 7:02 am
by Willie Two
Do I really need that that special socket to remove the large nut on the front discs as said in the manual ??? Thanks for the advice. It's a Bronco II 1984 4 x 4
Posted: Wed Jul 04, 2007 7:39 am
by garagedude
Yup, I had to buy one. I found mine at Napa. You will bugger up the nut if you use a hammer and chisel.
Posted: Wed Jul 04, 2007 8:51 am
by Nobody
It will make life much easier.
Posted: Wed Jul 04, 2007 11:23 am
by Willie Two
Thanks
Posted: Tue Jul 10, 2007 6:45 pm
by NCBII
for my manual hubs a big screw driver worked, for my autos ha that was a quick run to the parts store for a socket
Posted: Sun Jul 22, 2007 7:28 pm
by 84_4x4
Nobody wrote:It will make life much easier.
very much so and get a quality one the cheap ones are harder to use while torqeing