Page 1 of 1
replacing dana 28
Posted: Sun Jan 21, 2007 7:53 pm
by stupidcow79
hey broke my slip yoke off my u joint on my dana 28 everything is stock but yah i have a parts bronco it is an 84 with a dana 28. anything i should no about when taking off both axles and replacing it?
Posted: Sun Jan 21, 2007 8:50 pm
by tekatlarge
My only advice is to buy a Big box of Band-aides and a rack a beer!
Posted: Mon Jan 22, 2007 6:28 pm
by ranger5.0
I have found that 83 and 84's with automatics have different drivelines than newer models. The ones I have had, used a fullsize u-joint at both ends. Diffinetly stronger.
reply
Posted: Tue Jan 23, 2007 10:05 am
by stupidcow79
yah its a manual tranny but i hope its i little bit stronger then then the 88's