Page 1 of 1
MOUNT MY HL LIFT
Posted: Sun Jan 21, 2007 6:03 pm
by MIKRIB
still needs to be herculined
Posted: Fri Jan 26, 2007 11:09 pm
by Limited
Hey got any better pics?
I just got my high jack today. Was going to mount it on my front bumper but its a little too long. Would like to mount it on the back aswell.
Also my rear hatch is cracked though at the mounting plate, so I took off the latch. I want to put it back on but whats the best way to reinforce the cracked fiberglass around the mounting plate?
Posted: Fri Jan 26, 2007 11:44 pm
by Phillippi
MIKRIB that is a very sturdy place to mount the highlift. I had mine mounted like that since 1997. Its a good place, but make sure you take it off and clean out the mechanism a couple times a year so it wont seize up.
Posted: Sun Jan 28, 2007 8:29 am
by greenmachine89
Hey got any better pics?
I just got my high jack today. Was going to mount it on my front bumper but its a little too long. Would like to mount it on the back aswell.
Also my rear hatch is cracked though at the mounting plate, so I took off the latch. I want to put it back on but whats the best way to reinforce the cracked fiberglass around the mounting plate?
My buddy patched up the area that the fiberglass broke and mounted a piece of diamond plate over the area that the crack was. Seems to hold up very nicely.
Posted: Mon Jan 29, 2007 4:09 am
by MIKRIB
Limited wrote:Hey got any better pics?
I just got my high jack today. Was going to mount it on my front bumper but its a little too long. Would like to mount it on the back aswell.
Also my rear hatch is cracked though at the mounting plate, so I took off the latch. I want to put it back on but whats the best way to reinforce the cracked fiberglass around the mounting plate?
mine isnt cracked yet but when i get my 33" tires mounted im going to reinforce it like the latch is with a peice of back plate that runs the length of the hatck