Page 1 of 1
3" leaf spring questions...
Posted: Thu Jun 24, 2004 5:24 pm
by Phillippi
Ok I may be retarded, but I had a thought. When using 3" springs from a FS bronco, is it possible to cut 1/4" off either side of the eyes so it will fit in our 2 1/2" spring hanger already in place? Is this possible or am I dreaming of an easier swap.
Posted: Thu Jun 24, 2004 5:43 pm
by b2binbad
I made my own. Bronco2 main leaf, the rest are from a willys jeep. 6 leaves total.
--L
Posted: Sun Jun 27, 2004 7:29 am
by DBrown
you might be able to use an angle grinder to trim a little, but I have never tried it so it might give you problems.
Posted: Sun Jun 27, 2004 10:17 am
by Bronco19
James Duff has 3" leaf spring sets for $280 for BII. Just thought I'd mention it.