Another for EBSteve
Posted: Sun Mar 19, 2006 9:47 am
Tried to climb a car, I was scraping, Fri day night. I was only in 2 wheel drive. Thought you'd like it.
BroncoII4x4.com
Bronco II Off-Road Enthusiasts
https://www.broncoii4x4.com/forum/
Another for EBSteve
Page 1 of 1
Posted: Sun Mar 19, 2006 8:07 pm
nice job. You really did a number on that dshaft.
Posted: Sun Mar 19, 2006 8:22 pm
Ya here's my new one though, chopped one down out of the 3/4 ton. The t-case yoke was the same as the 1/2 one. So I didn't have to buy any special ones.
Posted: Tue Mar 28, 2006 6:15 pm
you need to quit posting all this evidence. 
Posted: Tue Mar 28, 2006 8:01 pm
you know if you spent all this time on fixing the ranger you could have been done by now 
that drive shaft looks good did you use a lathe or did you balance it?
that drive shaft looks good did you use a lathe or did you balance it?
Posted: Fri Mar 31, 2006 9:43 pm
I didn't use a lathe nor did I balance it. It still had a weight down by the slip yoke.
I am finding out that it really doesn't matter what rig I drive they all break the same parts.
I am finding out that it really doesn't matter what rig I drive they all break the same parts.