BroncoII4x4.com

how hard would it be to change a push botton 4x4 to a manual shifter

Unfortunately, you'll have to swap out the transfercase completely. Overall it would be pretty easy.

Unless you're having problems with the push button, I wouldn't bother.

ya i am havin problem with it, it is goin in to 4x4 but it aint showin low or hi i drive a 86 BII but i got a 84 BII manual 4x4 it needs a trans so im thankin bout swapin my trans to that one is that a good idea

If you have a manual shift T case and the shift linkage and boot and all then its really just a matter of cutting a hole in your floor. If you don't have the boot then you will need to find one or you will have lots of air coming in throuh your floor (trust me on that one)

Another thing to consider is that the older (manual) Tcases sometimes had differnt driveshafts so you will have to see if the flanges match up or if you will have to dome something to get your driveshafts to bolt up.

silly question...Is it going between HI and LOW when you want it to but its just not showing on the dash? If so maybe check the bulb in the dash. If the transfer case is working properly it would be a lot easier to just replace a switch for the light, or a light bulb, or just not look at it.

silly ? well sorry for askin you dude ive checked the bulb and it is the chip in under the bulb lol

I was saying my question about the bulb was silly so right back at ya

lol ok well there is another guy askin somethin like this what about changing the trans case and put the shifter in the floor is that goin to take alot time and money that aint worth it???

If the decision concerning Transfer Cases were up to me, I would use a manual case. If your trying to decide which is better the manual is.

The electric T case shifts via an electrical motor mounted on the outside of the case. 99% of shifting and not shifting problems are due to this motor. Not a bad design for street use but not for any serious off road. With that motor hanging out there it is exposed to more rocks, dirt and mud and water than street use.

The other downside is the auto hubs that usually accompany this Tcase. The auto hubs are JUNK best to swap in some manual hubs.

I probably missed the point but NO electric!!!!! To convert to manual is not a big deal but as earlier mentioned you may have to change both driveshafts.

Anyway have fun. That's my answer and I am sticking to it!

hey man that sounds good to me thanks for the time

what about a rusted top i got one its weak in spots do it my self ???????

bigdog wrote:what about a rusted top i got one its weak in spots do it my self ???????

Ahhh Can we say Sawzall....

Drain the t-case first if you are hellbent on swapping (The electric has never failed me). If you are big and burly, don't waste your time with a tranny jack, just be prepared for about a 70 lb bench press at a very awkward angle, I just benchpressed mine onto the output shaft and the alignment dowel, held it close with one hand and screwed on a bolt with the other. If you have big enough tires (235/75 or larger), you won't even have to jack it up. Oh yeah, and drain the transmission fluid, it stinks like ass if it gets on your clothes and it will come pouring out when the t-case comes off if you don't drain it.

Paul