Page 1 of 1
little triangles
Posted: Fri Jan 27, 2006 12:19 pm
by BIG Z DUDE
On the d44 where the radius arms connect there are to little triangles on each side of the axle that are part of the axle. what do I do, dont I have to move the mounts in 2". can I cut the triangles off or what. please help!!!!!!!!!!
I am running full width dana 44 and full width 9'' out of a 78 fs bronco
Posted: Fri Jan 27, 2006 12:40 pm
by Rockcrawler
well unfogantly you cant move them sense they are part of your knuckles. Your going to have to extend out your coil buckets.
Posted: Fri Jan 27, 2006 12:41 pm
by Nobody
Posted: Fri Jan 27, 2006 1:02 pm
by BIG Z DUDE
.
Posted: Fri Jan 27, 2006 5:14 pm
by Nobody
I guess you already figured it out.
The axle tube doesn't run all the way through the cast wedge assembly.
Posted: Sat Jan 28, 2006 5:34 am
by marinebroncoii
Here's a link to the weld on wedges from James Duff:
http://www.jamesduff.com/eb/suspension_components.html
I used these to set up F-150 radius arms on a F-250 D44 that was originally leaf sprung.