Carb and Distributer replacement

danny.root · Post by **danny.root** » Wed Dec 21, 2005 5:12 pm

I want to replace the carb and distributer in my 84 Bronco II . It has a six clyinder engien in it . I want to do away with all the electronic carbage that is on it now. Does anyone have any suggestions on if this can be done and where i can find the parts?any help would be great . thanks

OffroadBEAR · Post by **OffroadBEAR** » Wed Dec 21, 2005 5:23 pm

I don't know a whole lot about the 2.8, but if you want a non-electronically controlled carb and duraspark ingition, I would look for those parts form a Mustang II from the late 70's or similar cars from around that time that had the 2.8 V6. Also, offenhauser makes a 4 barrel intake for that engine, and a 390cfm carb on top of that makes good power from what I hear, but thats if you have money. There are a lot of other people here who know more about it than me, but thats where I would start. Also, for more guidance, you could look at the ranger station. (Don't worry I am not advertising).

Paul

vicsbronco · Post by **vicsbronco** » Thu Dec 22, 2005 8:06 am

I just finished Duraspark conversion on my 84 B2. Pretty simple, except I put
distributor 180 degree out. "Nobody" was right about my mistake, Thanks!
There is lots of info available here. I bought almost all parts new from Advanced and Napa- less than $300.