Page 2 of 2
Posted: Thu Jun 23, 2005 9:14 am
by Nobody
EBSTEVE wrote:
The brackets are fairly common at pull a part, I had one that I butchered
for my setup before I realized it would not work. You would still have to adapt the York to the bracket but it's a piece of cake.
That's why I asked. If it didn't fit on an EB, I figured there was no way it would fit on a BII. I think our frames are a little wider.
Posted: Thu Jun 23, 2005 4:20 pm
by broncoo
yeah there ain't much room from the p/s braket to the frame due to the pump sitting lower and more to the drivers side
Posted: Thu Jun 23, 2005 7:10 pm
by Bob
I used a gates #20923 (napa #7648)
One hose, with no kinks or funny bends.
Posted: Fri Jun 24, 2005 9:18 am
by EBSTEVE
Nobody wrote:That's why I asked. If it didn't fit on an EB, I figured there was no way it would fit on a BII. I think our frames are a little wider.
It was not the frame but the steering box, I don't think it would have been a problem if I would have had any other serpentine setup but mine is really short and made for problems.
I had to mill it down (IIRC it was 2+") and that made everything all jacked up.
Posted: Tue Jun 28, 2005 6:44 pm
by ranger5.0
I was trying to pull my pulleys off and found my rachet tack welded to the table.
