Page 2 of 2
Re: tire size
Posted: Sat Apr 18, 2009 6:32 pm
by Ranger Dave
john86 wrote:so they will not work at all. and also where do i get that kind of drive shaft
ive never done it,i get the right springs.the drive shaft is from a 91-94 xplorer
http://rangerdave.freeforums.org/explor ... -t233.html
Re: tire size
Posted: Mon Apr 20, 2009 7:33 pm
by Valleyboy54
i have 35x12.5 on my bronco II. i have a 4 in suspension lift and 3 in body lift and i have lots of body clearance from the tires. the stock drive shaft with the cvc joints wont work because of the angle. the drive shaft i put on was off of an 88 ranger i cut it to size.
Re: tire size
Posted: Thu Apr 23, 2009 7:28 am
by john86
so where do i find a drive shaft that is double cardan
Re: tire size
Posted: Thu Apr 23, 2009 7:33 am
by Ranger Dave
2 post up
Re: tire size
Posted: Tue May 12, 2009 8:56 pm
by jesse bowman
I have a 4 1/2 in lift eagle deep dish wheel and 33x15.50x15 and i dont rub at all but trust me and them u need that drive shaft i got one made with a slip yaoc and velocity joint and it worked find it wasn't that bad the drive shaft cost 230.00