Hey Nobody??

FatMan · Post by **FatMan** » Sun May 28, 2006 2:07 am

i know it's probably been awhile but im just currious is you remember why you have to us the chevy stub shaft when doing the chevy knuckle swap??

Post by **Nobody** » Sun May 28, 2006 10:00 am

You don't have to. You can use ford or chevy stubs. The only difference is the chevy stubs are slightly longer and allow you to put the outer c-clip on. I've run both the ford and chevy stubs, and I don't use the c-clips on either.

FatMan · Post by **FatMan** » Sun May 28, 2006 4:57 pm

sweet i was looking at it the other day and i was thinking the same (why did they put a c clip on the end)???? the shaft will only move a little so i wont worry.