little triangles

BIG Z DUDE · Post by **BIG Z DUDE** » Fri Jan 27, 2006 12:19 pm

On the d44 where the radius arms connect there are to little triangles on each side of the axle that are part of the axle. what do I do, dont I have to move the mounts in 2". can I cut the triangles off or what. please help!!!!!!!!!!

I am running full width dana 44 and full width 9'' out of a 78 fs bronco

Rockcrawler · Post by **Rockcrawler** » Fri Jan 27, 2006 12:40 pm

well unfogantly you cant move them sense they are part of your knuckles. Your going to have to extend out your coil buckets.

Post by **Nobody** » Fri Jan 27, 2006 12:41 pm

I already answered that in the other thread

http://forum.broncoii4x4.com/viewtopic.php?p=8135#8135

BIG Z DUDE · Post by **BIG Z DUDE** » Fri Jan 27, 2006 1:02 pm

Post by **Nobody** » Fri Jan 27, 2006 5:14 pm

I guess you already figured it out.

The axle tube doesn't run all the way through the cast wedge assembly.

marinebroncoii · Post by **marinebroncoii** » Sat Jan 28, 2006 5:34 am

Here's a link to the weld on wedges from James Duff:
http://www.jamesduff.com/eb/suspension_components.html
I used these to set up F-150 radius arms on a F-250 D44 that was originally leaf sprung.