lower rad hose

Post by **Nobody** » Thu Jun 23, 2005 9:14 am

EBSTEVE wrote: The brackets are fairly common at pull a part, I had one that I butchered for my setup before I realized it would not work. You would still have to adapt the York to the bracket but it's a piece of cake.

That's why I asked. If it didn't fit on an EB, I figured there was no way it would fit on a BII. I think our frames are a little wider.

broncoo · Post by **broncoo** » Thu Jun 23, 2005 4:20 pm

yeah there ain't much room from the p/s braket to the frame due to the pump sitting lower and more to the drivers side

Bob · Post by **Bob** » Thu Jun 23, 2005 7:10 pm

I used a gates #20923 (napa #7648)
One hose, with no kinks or funny bends.

EBSTEVE · Post by **EBSTEVE** » Fri Jun 24, 2005 9:18 am

Nobody wrote:That's why I asked. If it didn't fit on an EB, I figured there was no way it would fit on a BII. I think our frames are a little wider.

It was not the frame but the steering box, I don't think it would have been a problem if I would have had any other serpentine setup but mine is really short and made for problems.
I had to mill it down (IIRC it was 2+") and that made everything all jacked up.

ranger5.0 · Post by **ranger5.0** » Tue Jun 28, 2005 6:44 pm

I was trying to pull my pulleys off and found my rachet tack welded to the table.