Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
-
PHROX
- Posts: 95
- Joined: Wed Apr 28, 2004 3:01 pm
- Location: salt Lake City
-
Contact:
Post
by PHROX »
on my d44 I just blew out the berings on the drivers side u joint. is it possible to switch out the u joint without removing the axel shaft?
1987 Bronco2, d44/9" locked, sweet paint job. Now with available 5.0
-
Nobody
- Posts: 2233
- Joined: Sun Apr 18, 2004 6:38 pm
- Location: Stanwood, WA.
-
Contact:
Post
by Nobody »
No.
It only takes about 10 minutes to pull a shaft anyway.
-
PHROX
- Posts: 95
- Joined: Wed Apr 28, 2004 3:01 pm
- Location: salt Lake City
-
Contact:
Post
by PHROX »
rats, I seem to have bad luck when pulling axel shafts, but oh well
1987 Bronco2, d44/9" locked, sweet paint job. Now with available 5.0
