A4ld vent tube
-
dragster557
- Posts: 10
- Joined: Tue Jan 26, 2010 6:18 pm
- Location: burlington nc
A4ld vent tube
Blowing air hose into vent to see if it is stopped up.When i pull air hose out the pressure comes back out vent.Is it stopped up.Thanks
-
tekatlarge
- Posts: 992
- Joined: Tue Jan 17, 2006 8:54 am
- Location: Coastal, Worshington
Re: A4ld vent tube
??????
What do you call "The Vent"
What do you call "The Vent"
The Tek @ Large
Coastal,Worshington
Livin life on the dole on the Coast
Coastal,Worshington
Livin life on the dole on the Coast
-
tekatlarge
- Posts: 992
- Joined: Tue Jan 17, 2006 8:54 am
- Location: Coastal, Worshington
Re: A4ld vent tube
OK I just went out and looked at the 2 A4LDs I have out back and both have what appears to be a vent. My best guess is your vent is blocked. It doesn't look like that fitting screws in the case but is a press fit. Ya might be able to grab it with a vice-grip and wiggle it out and look there for a blockage.
I just went through my A4LD Manual and couldn't even find it shown on the cut a ways. Found a mention of a vent kit but not illustrated and only a part number.
One last thing to think about is it is possible that it is a one way vent outward. Try putting a vacuum on it and see if you have flow.
I just went through my A4LD Manual and couldn't even find it shown on the cut a ways. Found a mention of a vent kit but not illustrated and only a part number.
One last thing to think about is it is possible that it is a one way vent outward. Try putting a vacuum on it and see if you have flow.
The Tek @ Large
Coastal,Worshington
Livin life on the dole on the Coast
Coastal,Worshington
Livin life on the dole on the Coast