need help please

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
flgataznumber1
Posts: 6
Joined: Mon Jul 13, 2009 6:31 pm

need help please

Post by flgataznumber1 »

my 84 bronco2 has a 4sp manual trans. i think my trans is goin out because in first it sounds like broken gears grinding together. in second its ok just sounds like its rapping out. in third it grinds like first and fourth it grinds like first. do i need a new transmission?

if i need a new one i want to put a v8 in my b2. probably a 302 from an early 90's f150. should i just go buy that f150 and swap out everything or what should i do. this is my favorite vehicle in a while and i need more power and a new trans.

please any ideas?
User avatar
RClem
Posts: 94
Joined: Sun Oct 25, 2009 5:38 am
Location: Yakima

Re: need help please

Post by RClem »

Start with a look at this link: http://www.therangerstation.com/tech_li ... sions.html
Then remember this was written a few years back.
If you check around the different RBV forums, you will find a lot of information on doing a 5.0L (302) swap.

Ray
Post Reply