Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
CK3
Posts: 12 Joined: Wed Jun 10, 2009 2:32 pmLocation: Minooka, IL
Contact:
Post
by CK3 Fri Jun 19, 2009 8:16 pm
I picked up an '89 B2 XLT 4x4 a few days ago. Everything works great.
It needs a little TLC but it will be a cool project. Today I bought the front & rear Bushwacker cut-outs. I'm going to run 33x14.5 Super Swampers on it. I'm looking for an affordable 6" lift kit. Whats out there?
Also.. Anyone make a cat-back for the 2.9L??
Thanks
Ranger Dave
Posts: 1435 Joined: Sun Oct 10, 2004 5:53 amLocation: Newbury NH
Contact:
Post
by Ranger Dave Sat Jun 20, 2009 4:50 am
hope you plan on regearing. might wanna think about swappin in a 5spd or finding a good low miles 4.0 A4LD(91 ta 94)
CK3
Posts: 12 Joined: Wed Jun 10, 2009 2:32 pmLocation: Minooka, IL
Contact:
Post
by CK3 Sat Jun 20, 2009 7:19 am
Ranger Dave wrote: hope you plan on regearing. might wanna think about swappin in a 5spd or finding a good low miles 4.0 A4LD(91 ta 94)
I'm going to do a 5.0 swap later this summer. I'm not sure what to do for gears yet.
