PLEASE HELP!?!?!?!?!?!

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
User avatar
Ranger Dave
Posts: 1435
Joined: Sun Oct 10, 2004 5:53 am
Location: Newbury NH
Contact:

Re: PLEASE HELP!?!?!?!?!?!

Post by Ranger Dave »

Hmmmmm,looks like you have a wiring night mare. i had a wiring diagram of the fuel pumps,but i cant find it. the relay needs to get power when the key is turned on,then it goes to the inertia switch then the pumps
86broncII
Posts: 69
Joined: Sat Feb 14, 2009 6:43 pm

Re: PLEASE HELP!?!?!?!?!?!

Post by 86broncII »

yeah its pretty bad but i am sure i will get threw it sooner or later, but i do have a pulse wire to the pump, and i think the only wireing i havent looked at yet is the wireing at the high pressure pump but i will check it out
86 bronco II
2.9l v6 5speed
5.5" superlift with 33 12.5s super swampers
86broncII
Posts: 69
Joined: Sat Feb 14, 2009 6:43 pm

Re: PLEASE HELP!?!?!?!?!?!

Post by 86broncII »

well good news, i got my bronco a new wireing harness and i am pickin it up tomorrow around noon so that will solve most of my wireing problems hopefully
86 bronco II
2.9l v6 5speed
5.5" superlift with 33 12.5s super swampers
User avatar
Ranger Dave
Posts: 1435
Joined: Sun Oct 10, 2004 5:53 am
Location: Newbury NH
Contact:

Re: PLEASE HELP!?!?!?!?!?!

Post by Ranger Dave »

that is a good idea. glad you found one. hopfully that one hasent been cut up. grab the computer too if you can
86broncII
Posts: 69
Joined: Sat Feb 14, 2009 6:43 pm

Re: PLEASE HELP!?!?!?!?!?!

Post by 86broncII »

ok so i got the new wiring harness in and i have 2 plugs that i am not sure where they go, here is a picture of the 2 plugs i am talking about and also the plug that comes out of the coil pack has 2 red wires, where does the one with the plug on the end go?
Attachments
022009_1056[01].jpg
022009_1056[00].jpg
86 bronco II
2.9l v6 5speed
5.5" superlift with 33 12.5s super swampers
User avatar
Ranger Dave
Posts: 1435
Joined: Sun Oct 10, 2004 5:53 am
Location: Newbury NH
Contact:

Re: PLEASE HELP!?!?!?!?!?!

Post by Ranger Dave »

1st one, washer pump?
2nd one, goes to the condenser on the coil bracket
86broncII
Posts: 69
Joined: Sat Feb 14, 2009 6:43 pm

Re: PLEASE HELP!?!?!?!?!?!

Post by 86broncII »

i dont think its the washer pump because it works without it and the other one actually comes out of the coil pack plug and can you take a picture of your starter relay thats on the pasenger side by the battery and relays?
86 bronco II
2.9l v6 5speed
5.5" superlift with 33 12.5s super swampers
User avatar
Ranger Dave
Posts: 1435
Joined: Sun Oct 10, 2004 5:53 am
Location: Newbury NH
Contact:

Re: PLEASE HELP!?!?!?!?!?!

Post by Ranger Dave »

my washer plus has two wires
Attachments
Picture 415.jpg
Picture 414.jpg
86broncII
Posts: 69
Joined: Sat Feb 14, 2009 6:43 pm

Re: PLEASE HELP!?!?!?!?!?!

Post by 86broncII »

ok well the one i showed you in the first picture has 2 black wires and then a green and black one
86 bronco II
2.9l v6 5speed
5.5" superlift with 33 12.5s super swampers
User avatar
Ranger Dave
Posts: 1435
Joined: Sun Oct 10, 2004 5:53 am
Location: Newbury NH
Contact:

Re: PLEASE HELP!?!?!?!?!?!

Post by Ranger Dave »

i have no clue. what year did that harness come out of??
86broncII
Posts: 69
Joined: Sat Feb 14, 2009 6:43 pm

Re: PLEASE HELP!?!?!?!?!?!

Post by 86broncII »

it came off an 87
86 bronco II
2.9l v6 5speed
5.5" superlift with 33 12.5s super swampers
86broncII
Posts: 69
Joined: Sat Feb 14, 2009 6:43 pm

Re: PLEASE HELP!?!?!?!?!?!

Post by 86broncII »

ok so i was under my b2 and i found this plug that i am not sure if it is important or not it was by the starter, and it is round, anyone know what it is, here is a picture of it
022109_1239[00].jpg
86 bronco II
2.9l v6 5speed
5.5" superlift with 33 12.5s super swampers
User avatar
Ranger Dave
Posts: 1435
Joined: Sun Oct 10, 2004 5:53 am
Location: Newbury NH
Contact:

Re: PLEASE HELP!?!?!?!?!?!

Post by Ranger Dave »

all the lights work?? tail light,brake lights ect
86broncII
Posts: 69
Joined: Sat Feb 14, 2009 6:43 pm

Re: PLEASE HELP!?!?!?!?!?!

Post by 86broncII »

yea all of the lights work,everything works the power windows locks all lights turn signals hazards, everything works, it just does not get fuel, is the fuel vacume assist?
86 bronco II
2.9l v6 5speed
5.5" superlift with 33 12.5s super swampers
User avatar
Ranger Dave
Posts: 1435
Joined: Sun Oct 10, 2004 5:53 am
Location: Newbury NH
Contact:

Re: PLEASE HELP!?!?!?!?!?!

Post by Ranger Dave »

86broncII wrote: is the fuel vacume assist?
nope. have you tried by-passing the inertia switch??
Post Reply