Home build schakles

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
WaPaul
Posts: 34
Joined: Sun Nov 16, 2008 8:17 pm

Home build schakles

Post by WaPaul »

I made up some schakles today to level out my B2. It sat level before I installed a 4" lift and after it sat 2 3/4" lower in the rear.

Image

Image

Image
Top
WaPaul
Posts: 34
Joined: Sun Nov 16, 2008 8:17 pm

Re: Home build schakles

Post by WaPaul »

this is before the schackles where installed

Image


this is after

Image

Image
Top
User avatar
Phillippi
Posts: 1193
Joined: Mon Apr 19, 2004 9:11 pm
Location: UTAH
Contact:
Contact Phillippi

Re: Home build schakles

Post by Phillippi »

Can you put the measurements on the pic for those of us who would like to build some of these please? Looks good.
Top
WaPaul
Posts: 34
Joined: Sun Nov 16, 2008 8:17 pm

Re: Home build schakles

Post by WaPaul »

yes I will get the info for you, sorry I have been away for a while.
Top
User avatar
Ranger Dave
Posts: 1435
Joined: Sun Oct 10, 2004 5:53 am
Location: Newbury NH
Contact:
Contact Ranger Dave

Re: Home build schakles

Post by Ranger Dave »

hows the rear driveshaft likein that much lift/angle
Top
WaPaul
Posts: 34
Joined: Sun Nov 16, 2008 8:17 pm

Re: Home build schakles

Post by WaPaul »

seems OK. I am almost done with the V8 swap so I will have to change the driveline to a real DL. I will add a CV joint in the new DL so it will work fine.
Top
Post Reply

Return to “Bronco Tech”